2022 Kawasaki Vulcan 1700 Vaquero ABS Idle Speed Owners Manual

2022 Kawasaki CONCOURS 14 ABS LOGO PRODUCT

2022 Kawasaki Vulcan 1700 Vaquero ABS Idle Speed

2022-Kawasaki-Vulcan-1700-Vaquero-ABS-Product-Image

Idle Speed

The idle speed adjustment should be performed in accordance with the Periodic Maintenance Chart or whenever the idle speed is disturbed. The follow- ing procedure covers the idle speed adjustment.

Idle Speed
950 rimin (rpm)

Adjustment
E TV controls the idle speed preset in accordance with the following procedure. If necessary change the idle speed to meet the factory specified range.

  • Shift the transmission into neutral.
  • Start the engine, and warm it up thoroughly.
  • Push the “S” button for more than two seconds to display the unit setting menu.
  • Push the “S” button to display the idle speed adjusting mode.2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-124
NOTE
  • Without having the engine started, the idle speed adjusting mode is not displayed.
  • When the coolant temperature is low, the idle speed adjusting mode is sometimes not displayed. In that case, warm up the engine thoroughly first, and then push the “S” button again to display the idle speed adjusting mode.

    2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-125

  • Adjust the idle speed by pushing the “MODE-A” or “MODE-B” switches.
  • The idle speed goes up 50 r/min (rpm) at one time by pushing the “MODE-A” switch, and goes down 50 r/min (rpm) at one time by pushing the “MODE-B” switch.

    2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-126

A. “MODE-A” Switch
B. “MODE-B” switch

Idle Speed Adjusting Range
850 1 100 r/min (rpm)

NOTE

  • The initial setting idle speed is 950 r/min (rpm).
  • The numerical values on the display show the difference between the ac- tual idle speed and the initial setting idle speed. The numerical values “+100” shown on the display as be- low indicate the actual idle speed “I 050 rpm”.

2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-127A 1 050 r/min (rpm)

  • Push the “MODE-B” switch for more than two seconds to return the idle speed to the initial setting.
  • Push the “S” button to return to the unit setting menu.
  • Open and close the throttle a few times to make sure that the idle speed does not change. Readjust if necessary.
  • With the engine idling, turn the handlebar to each side. If handlebar movement changes the idle speed, the throttle cables may be improperly adjusted or incorrectly routed, or they may be damaged. Be sure to correct any of these conditions before riding.

WARNING
Operation with damaged cables could result in unsafe riding conditions. Replace damaged control cables before operation.

Leave a Comment