Alarm indicator
- LED is not lit – alarm not armed.
- The LED flashes once every other second – the alarm is armed.
- After the alarm has been disarmed, the LED flashes rapidly for a maximum of 30 seconds or until ignition position I have been activated – the alarm has been triggered.
When armed, the alarm is triggered if:
- a door, the bonnet, or the tailgate is opened
- a movement is detected in the passenger compartment (if fitted with a movement detector)
- the car is raised or towed away (if fitted with a tilt detector)
- the battery is disconnected
- the siren is disconnected.
Alarm signals
When the alarm has been triggered, the following happens:
- A siren sounds for 30 seconds or until the alarm is switched off.
- Hazard warning flashers flash for 5 minutes or until the alarm is switched off.
If the cause of alarm activation is not rectified, the alarm cycle is repeated up to 10 times.
Movement and tilt sensors
To avoid triggering the alarm unintentionally:
- Close all windows when leaving the car.
- Close the panoramic roof.
- If climate control is used – aim the airflow so that it does not point upwards in the passenger compartment.
It is also possible to reduce the alarm level in the center display.
Symbols and messages
Symbol | Message | Specification |
---|---|---|
| Alarm system failure service required | Contact a workshop – an authorized Volvo workshop is recommended. |
Activating and deactivating alarms
Activating and deactivating alarms
The alarm is activated when the car is locked and is deactivated when the car is unlocked.
Deactivate the alarm without a functioning key
- The car can be unlocked and disarmed even if the key does not work, e.g. if the key’s battery is discharged.
- Open the driver’s door with the detachable key blade.
- The alarm is triggered.
Place the key on the key symbol in the backup reader in the tunnel console’s cup holder.- Turn the start knob clockwise and release it.
- The alarm is deactivated.
Switching off a triggered alarm
Press the key’s unlock button or select ignition position I by turning the start knob clockwise and then releasing.
Reduced alarm level
- Reduced alarm level switches off certain types of alarm sensors so that a false alarm is not triggered, e.g. when traveling on a car ferry.
- The alarm’s movement and tilt detectors are deactivated when a reduced alarm level is activated.
- The alarm then does not react to movement inside the car.
- The reduced alarm level is deactivated after each usage and must therefore be reactivated.
Activating reduced alarm level
- Press the Reduced Guard button in the center display function view.
- The function is active until the car is driven, and must therefore be reactivated.