Using a stored setting
A stored setting can be used with the front door either open or closed:
Open front door
Press one of the memory buttons 1 – 3 with a brief touch. Power seat, door mirrors, and head-up display move and then stop at the positions stored in the selected memory button.
Closed front door
- Hold one of the memory buttons 1 – 3 depressed until the seat, door mirrors, and head-up display stop in the positions that are stored in the selected memory button.
- If the memory button is released, the movement of the seat, door mirrors, and head-up display will be stopped.
Warning
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- Make sure there is nothing under the seats when they are being adjusted.
NoteThe stored positions are saved in the active profile.
Storing position for seat, door mirrors and head-up display
(Option/accessory)
You can store the position for the power(Option/accessory) seat, door mirrors and head-up display in the memory buttons.
Store three different positions for the power(Option/accessory) seat, the door mirrors and the head-up display using the memory buttons. The buttons are located on the inside of one of the front doors or both(Option/accessory).
- Memory button.
- Memory button.
- Memory button.
- Button M for storing settings.
Storing a position
- Adjust the seat, door mirrors and head-up display to the desired position.
- Press and hold the M button depressed. The light indicator in the button illuminates.
- Within three seconds, press and hold the 1, 2, or 3 buttons.
- When the position has been stored in the selected memory button, an acoustic signal can be heard and the light indicator in the M button extinguishes.
If none of the memory buttons is depressed within three seconds then the M button extinguishes and no storing takes place.
The seat, the door mirrors, or the head-up display must be readjusted before a new memory can be set.
Note
The stored positions are saved in the active profile.