2023 Volvo XC40 Recharge Plug-in Hybrid Memory function for front seat
Using a stored position for seat and door mirrors
If the positions for the power seat and the door mirrors have been stored, they can be activated by using the memory buttons.
Using a stored setting
A stored setting can be used with the front door either open or closed:
Open front door
Depress one of the memory buttons 1 (2) or 2 (3) with a short press. The power seat and door mirrors move and then stop at the positions stored in the selected memory button.
Closed front door
- Hold one of the memory buttons 1 (2) or 2 (3) depressed until the seat and door mirrors stop in the positions that are stored in the selected memory button.
- If the memory button is released, the movement of the seat and door mirrors will be stopped.
Warning
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- Make sure there is nothing under the seats when they are being adjusted.
Storing a position for seat and door mirrors
You can store the position for the power seat and door mirrors in the memory buttons.
Store two different positions for the power seat and the door mirrors using the memory buttons. The buttons are located on the inside of one of the front doors or both.
- Button M for storing settings.
- Memory button.
- Memory button.
Storing a position
- Adjust seat and door mirrors to the desired position.
- Press and hold the M button depressed. The light indicator in the button illuminates.
- Within three seconds, press and hold the 1 or 2 buttons.
- When the position has been stored in the selected memory button, an acoustic signal can be heard and the light indicator in the M button extinguishes.
If none of the memory buttons is depressed within three seconds then the M button extinguishes and no storing takes place.
The seat or the door mirrors must be readjusted before a new memory can be set.