The indicator for locks and alarm is located in the centre of the instrument panel, close to the windscreen.
A red indicator light shows the status of the alarm system:
- Extinguished – alarm not armed.
- Flashes once every other second – alarm is armed.
- After the alarm has been disarmed, flashes rapidly for a maximum of 30 seconds or until ignition position I has been activated – the alarm has been triggered.
When armed, the alarm is triggered if:
- a door, the bonnet or the tailgate is opened
- a movement is detected in the passenger compartment (if fitted with a movement detector)
- the car is raised or towed away (if fitted with a tilt detector)
- the battery is disconnected
- the siren is disconnected.
When the alarm has been triggered, the following happens:
- A siren sounds for 30 seconds or until the alarm is switched off.
- Hazard warning flashers flash for 5 minutes or until the alarm is switched off.
If the cause of alarm activation is not rectified, the alarm cycle is repeated up to 10 times.
Movement and tilt sensors
To avoid triggering the alarm unintentionally:
- Close all windows when leaving the car.
- Close the panoramic roof.
- If the climate control is used – aim the airflow so that it does not point upwards in the passenger compartment.
It is also possible to reduce the alarm level in the centre display.
Symbol | Message | Specification |
---|---|---|
| Alarm system failureService required | Contact a workshop – an authorised Volvo workshop is recommended. |
Do not attempt to repair or alter components in the alarm system yourself. Any such attempts may affect the terms of the insurance.
Activating and deactivating alarms
The alarm is activated when the car is locked, and is deactivated when the car is unlocked.
Deactivate the alarm without a functioning key
- The car can be unlocked and disarmed even if the key does not work, e.g. if the key’s battery is discharged.
- Open the driver’s door with the detachable key blade.
- The alarm is triggered.
- Place the key on the key symbol in the back-up reader in the tunnel console’s storage compartment.
- Press the start button.
- The alarm is deactivated.
Press the key’s unlock button or select ignition position I by pressing the start button.
Reduced alarm level
Press the Reduced Guard button in the centre display function view.the function is active until the car is driven, and must then be reactivated.