Examples of information that can be shown:
- cruise control
- speed
- navigation
- telephone call
- traffic sign information
- warnings
Activating and deactivating the head-up display
- Press
- Select Controls.
- Under Displays, activate or deactivate the Head-up display.
Note
The driver’s ability to see the information in the head-up display is impaired by the following
- use of polarising sunglasses
- a driving position which means that the driver is not sitting centered in the seat
- objects on the display unit’s cover glass
- unfavorable light conditions.
Important
The display unit from which the information is projected is located in the instrument panel. To avoid damage to the display unit’s cover glass – do not store any objects on the cover glass and make sure that no objects fall down onto it.
Note
Certain visual defects may cause headaches and a feeling of stress during the use of the head-up display.
Settings for head-up display
System settings
Settings can be defined when the car has started and a projected image is shown on the windscreen.
- Press
- Select Controls.
- Select the setting to be adjusted under Displays.
Click on the setting to be adjusted.
You can use the steering wheel’s right-hand keypad to adjust position or brightness.
- Reducing the brightness
- Increasing the brightness
- Raising the position
- Lowering the position
- Confirm
Rotation
The display may need to be rotated when replacing the windscreen or display unit.
Click on the setting to be adjusted.
You can use the steering wheel’s right-hand keypad to rotate the display.
- Rotate anticlockwise
- Rotate clockwise
- Confirm
Cleaning the Head-up display
Never use strong stain removers. A special cleaning agent available from Volvo dealers can be used for more difficult cleaning.
Using a stored position for a seat, door mirrors, and head-up display
Using a stored setting
Open front door
Depress one of the memory buttons 1 (2) or 2 (3) with a short press. Power seat, door mirrors, and head-up display move and then stop at the positions stored in the selected memory button.
Closed front door
Hold one of the memory buttons 1 (2) or 2 (3) depressed until the seat, door mirrors, and head-up display stop in the positions that are stored in the selected memory button.
If the memory button is released, the movement of the seat, door mirrors, and head-up display will be stopped.
Warning
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- Make sure there is nothing under the seats when they are being adjusted.
Note
The stored positions are saved in the active profile.
Storing position for a seat, door mirrors, and head-up display
Store two different positions for the power seat, the door mirrors, and the head-up display using the memory buttons. The buttons are located on the inside of one of the front doors or both.
- Button M for storing settings.
- Memory button.
- Memory button.
Storing a position
- Adjust the seat, door mirrors, and head-up display to the desired position.
- Press and hold the M button depressed. The light indicator in the button illuminates.
- Within three seconds, press and hold the 1 or 2 buttons.
When the position has been stored in the selected memory button, an acoustic signal can be heard and the light indicator in the M button extinguishes.
If none of the memory buttons is depressed within three seconds then the M button extinguishes and no storing takes place.
The seat, the door mirrors, or the head-up display must be readjusted before a new memory can be set.
Note
The stored positions are saved in the active profile.