Location of BLIS lamp
BLIS is a driver aid intended to give a warning of:
- vehicles in the car’s blind spot
- quickly approaching vehicles in the left and right lanes closest to the car.
- Zone in blind spot
- Zone for quickly approaching vehicle
The system is designed to react when:
- your car is overtaken by other vehicles
- another vehicle is approaching your own car at speed.
When BLIS detects a vehicle in Zone 1 or a quickly approaching vehicle in Zone 2, the indicator lamp on the door mirror on the right or left illuminates with a constant glow. If the driver activates the direction indicator on the same side as the warning, the indicator lamp will change over from a constant glow to flashing with a more intense light.
- BLIS is active when the driver’s vehicle is travelling at a speed above 12 km/h (7 mph).
- If passing vehicles drive more than 15 km/h (9 mph) faster than the driver’s vehicle, BLIS will not react.
Note
The lamp illuminates on the side of the car where the system has detected the vehicle. If the car is overtaken on both sides at the same time then both lamps illuminate.
The lamp illuminates on the side of the car where the system has detected the vehicle. If the car is overtaken on both sides at the same time then both lamps illuminate.
Warning
- The function is supplementary driver support intended to facilitate driving and make it safer – it cannot handle all situations in all traffic, weather and road conditions.
- The driver is advised to read all sections in the Owner’s Manual that relate to this function to learn about factors such as its limitations and what the driver should be aware of before using the system.
- Driver support functions are not a substitute for the driver’s attention and judgement. The driver is always responsible for ensuring the car is driven in a safe manner, at the appropriate speed, with an appropriate distance to other vehicles, and in accordance with current traffic rules and regulations.
Messages for BLIS
A number of messages regarding BLIS can be shown in the driver display. Here are some examples.
| Message | Specification |
|---|---|
| Blind spot sensor Service required | The system does not function as it should. A workshop should be contacted. |
| Blind spot system off Trailer attached | BLIS and Cross Traffic Alert have been deactivated as a trailer has been connected to the car’s electrical system. |
- A text message can be cleared by briefly pressing the
- If a message remains, contact a workshop – an authorised Volvo workshop is recommended.
Limitations of BLIS
The BLIS function may have limitations in certain situations.
Examples of limitations:
- Dirt, ice and snow covering the sensors may reduce the functions and deactivate alerts.
- The BLIS function is automatically deactivated if a trailer, bicycle rack or similar is connected to the car’s electrical system.
- For good performance of BLIS, there should be no bicycle rack, luggage carrier or similar mounted on the car’s towbar.
Warning
- BLIS does not work on sharp bends.
- BLIS does not work when the car is reversing.
Note
This function uses the car’s radar units, which have certain general limitations.
This function uses the car’s radar units, which have certain general limitations.