System settings
Settings can be defined when the car has started and a projected image is shown on the windscreen.
- Press
- Select Controls.
- Select the setting to be adjusted under Displays.
Adjusting the position or brightness
The information in the display is automatically adapted to the background lighting conditions. The brightness is also affected when the brightness in the car’s other displays is adjusted. Click on the setting to be adjusted.
You can use the steering wheel’s right-hand keypad to adjust position or brightness.
- Reducing the brightness
- Increasing the brightness
- Raising the position
- Lowering the position
- Confirm
Rotation
The display may need to be rotated when replacing the windscreen or display unit. Click on the setting to be adjusted.
You can use the steering wheel’s right-hand keypad to rotate the display.
- Rotate anticlockwise
- Rotate clockwise
- Confirm
Cleaning the Head-up display (Option/accessory)
Using a stored position for the seat, door mirrors, and head-up display (Option/accessory)
Using a stored setting
A stored setting can be used with the front door either open or closed:
Open front door
Depress one of the memory buttons 1 (2) or 2 (3) with a short press. Power seat, door mirrors, and head-up display move and then stop at the positions stored in the selected memory button.
Closed front door
Hold one of the memory buttons 1 (2) or 2 (3) depressed until the seat, door mirrors, and head-up display stop in the positions that are stored in the selected memory button. If the memory button is released, the movement of the seat, door mirrors, and head-up display will be stopped.
Warning
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- Make sure there is nothing under the seats when they are being adjusted.
The stored positions are saved in the active profile.
Storing position for the seat, door mirrors, and head-up display (Option/accessory)
- Button M for storing settings.
- Memory button.
- Memory button.
Storing a position
- Adjust the seat, door mirrors, and head-up display to the desired position.
- Press and hold the M button depressed. The light indicator in the button illuminates.
- Within three seconds, press and hold the 1 or 2 buttons.
When the position has been stored in the selected memory button, an acoustic signal can be heard and the light indicator in the M button extinguishes.
If none of the memory buttons is depressed within three seconds then the M button extinguishes and no storing takes place. The seat, the door mirrors or the head-up display must be readjusted before a new memory can be set.
The stored positions are saved in the active profile.