Connect your phone to the car via Bluetooth. Go to settings
If the phone has been connected previously, tap on the icon for tethering via Bluetooth for the phone you want to use. Otherwise, first select Pair new device.
Approve, via the message shown, that the connection should take place.
The car is connected to the Internet.
Phone
When a phone has been connected and linked to the car as a phone device, it can be used make calls, send/receive messages, and play back media wirelessly.
The phone is operated from the centre display, but also partly via voice control.
Managing contacts
- When a phone is connected to the car, contacts can be managed directly in the centre display.
- When a phone is connected to the car using Bluetooth and is selected as phone device, contacts are shown in the phone app under their own tab.
- Before the contacts are shown in the car, sharing of contacts must be accepted in the phone.
- Browse through your contacts by swiping up or down.
- It is possible to show the phone’s favourites in the car.
The contacts are not shown
It may take a while before the contacts are loaded. If they are still not shown after a while, try disconnecting and reconnecting the phone.
Managing phone calls
Making a call from the phone app
- Open the phone app from the home view or app view
. - Choose a contact from Favourites, Recents or Contacts. Alternatively, enter a telephone number using the keypad.
- Tap
on the contact to make a call. - Tap on
to end the call. - You can also make calls using voice control.
Receiving a call
Incoming phone calls are shown and managed via the centre display.
Tap on
Tap on
Receiving a new call during a current call
Switching off the microphone
Toggling between car and phone speakers
Tap on CarPhone to toggle the sound between the speakers in the car and the phone speaker.
Using the keypad during a current call
Missed calls
Missed calls are shown in the home view where it is also possible to call back. Missed calls are also shown in the notification view at the top of the centre display.
Managing text messages
To be able to manage text messages in the car, the phone must be connected via Bluetooth as phone device and the user must have approved in the phone’s Bluetooth settings that notifications should be shown.
Sending text messages
You can dictate a new message by asking the voice control system to send a message to a named contact or a phone number.
Receiving text messages
When the phone is connected to the car, a notification is shown at the top of the centre display when a new text message is received. Choose whether to play back the message by tapping on the screen or using voice control.
It is also possible to choose to mute the conversation. In which case, no more notifications for the conversation are shown while driving.
Replying to text messages
When a text message has been read out, it is possible to dictate a reply. Follow the instructions given by the voice control system.
Text messages are not shown
If new text messages are shown on the phone but not in the centre display, try disconnecting and reconnecting the phone.
Wireless phone charger
Using the wireless telephone charger
Wireless phone charger in the tunnel console.
The charging pad can be activated and deactivated via the centre display. The default mode is that the charging plate is not activated. When the charging plate is switched on, a message is shown about the risks to users with an implanted pacemaker or other devices that could be affected by the charging plate. Confirm that the charging plate should be switched on in the centre display.
Remove all other objects from the charging plate and position the phone in the centre of the charging plate.
Phone charging is started and the symbol is shown at the top in the centre display.
Activating and deactivating
The wireless phone charger can be activated and deactivated from the centre display.
Go to settings
Select to activate or deactivate the wireless phone charger.
Confirm that the charger is to be activated.
If the phone does not charge:
- Check in the centre display that the charging pad is activated.
- Check that the charging plate is free from other objects.
- Check that the phone supports wireless charging (Qi).
- Remove the case from the phone if one is fitted.
- Lift the phone and position it in the centre of the charging plate once again.
- Check that the car is running.
- Check that your phone has not slid off the charging pad while driving.
- If battery temperature becomes too high during charging, the charging function is deactivated.
- If any of the doors are opened, charging is interrupted for several seconds.
If objects prevent charging on the charging plate, a message is shown in the centre display.
Certificate for wireless charger
Country/Area | ||
---|---|---|
China: | (一)符合“微功率短距离无线电发射设备目录和技术要求”的具体条款和使用场景,采用的天线类型和性能,控制、调整及开关等使用方法; (二)不得擅自改变使用场景或使用条件、扩大发射频率范围、加大发射功率(包括额外加装射频功率放大器),不得擅自更改发射天线; (三)不得对其他合法的无线电台(站)产生有害干扰,也不得提出免受有害干扰保护; (四)应当承受辐射射频能量的工业、科学及医疗(ISM)应用设备的干扰或其他合法的无线电台(站)干扰; (五)如对其他合法的无线电台(站)产生有害干扰时,应立即停止使用,并采取措施消除干扰后方可继续使用; (六)在航空器内和依据法律法规、国家有关规定、标准划设的射电天文台、气象雷达站、卫星地球站(含测控、测距、接收、导航站)等军民用无线电台(站)、机场等的电磁环境保护区域内使用微功率设备,应当遵守电磁环境保护及相关行业主管部门的规定; (七)禁止在以机场跑道中心点为圆心、半径5000米的区域内使用各类模型遥控器; (八)微功率设备使用时温度和电压的环境条件。 | |
Mexico: | RCPVAPVO 18-1919 | |
Paraguay: | | |
Taiwan: | 根據NCC低功率電波輻射性電機管理辦法 規定: 第十二條 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。 前項合法通信,指依電信法規定作業之無線電通信。 低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 | |
Ukraine: | Ци Діапазон частот: 107 кГц – 115 кГц Максимальна потужність радіосигналу: 5 Вт (сполучена), 63 Вт наномасштабів (випромінюється) Коефіцієнт викидів: N / A Модуляції: 2 кГц NFC Діапазон частот: 13,56 МГц, у межах +/- 0,01% Максимальна вихідна потужність РФ: 10 мВт – виробник: Ел-Джі Електронікс Інк.(LG Electronics Inc) 10, Магок’юнганг 10-ро, Гангсео-гу, Сеул, 07796, Корея Frequency range 111 кГц / Максимальна потужність РЧ: 42 дБмк А / м справжнім Ел-Джі Електронікс Інкзаявляє, що тип радіообладнання WC510MVV20 відповідає Технічному регламенту радіообладнання; повний текст декларації про відповідність доступний на веб-сайті за такою адресою:https://www.lg.com/global/support/cedoc/cedoc. імпортер : Віннер Імпортс Україна Вул. Дачна, 5-А, с.Капітанівка, Київська область, 08112, Україна Тел.: +38(044) 585 63 00 Контактна особа : Alla Haidai (ahaidai@winner.ua) | |
USA/Canada | FCC ID : BEJWC510MVV20 IC : 2703H-WC510MVV20 This device complies with part 15 of the FCC rules and with RSS-Gen,RSS-216 rules of Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changed or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 15cm between the radiator and your body. – IDéclaration d’avertissement ISED Son fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas provoquerd’interferences nuisibles, et (2) Cet appareil doit accepter toute interference recue, y compris les interferences pouvant entrainerun fonctionnement indesirable. Les changements ou modifications non expressement approuves par LG Vehicle Components Company pourraient annuler l’autorite de l’utilisateura utilizer l’equipement. Déclaration d’exposition aux radiations RF de l’ISED: Cet équipement est conforme aux limites d’exposition aux rayonnements RF de l’ISED définies pour un environnement non contrôlé. Cet appareil et son antenne ne doivent pas être situés ou fonctionner conjointement avec une autre antenne ou un autre émetteur. Cet équipement doit être installé pour fonctionner avec une distance minimale de 10cm entre le radiateuret le corps de l’utilisateur final. |