S60 Recharge Plug-in Hybrid

2023 Volvo S60 Recharge Plug-in Hybrid Wiper Blades and Washer Fluid Owners Manual

2023 Volvo S60 Recharge Plug-in Hybrid Wiper blades and washer fluid

Wiper blades and washer fluid

Together with the washer fluid, the wipers aim to improve visibility as well as headlamp pattern.
The wiper blades are heated automatically in cold weather to improve winter properties and to prevent the washer fluid from freezing.|
Information indicating that the washer fluid needs topping up appears in the driver display when there is approx. 1 litre (1 qt) of washer fluid remaining.

Setting the wiper blades in service position

In some situations, the windscreen’s wiper blades must be set in service position (vertical position), e.g. when they shall be replaced.

Wiper blades in service position.
In order to change, clean or lift the wiper blades (e.g. for scraping off ice from the windscreen) they must be in service position.

Important
Before placing the wiper blades in the service position, make sure that they are not frozen down.

Activating/deactivating service mode

Service mode can be activated/deactivated when the car is stationary and the windscreen wipers are not on. Service mode is activated/deactivated via the centre display:

Press in the centre display.
Then tap on Controls and activate/deactivate wiper blade service position.

The wiper blades also exit the service position if:

  • Windscreen wiping is activated.
  • Windscreen washing is activated.
  • The rain sensor is activated.
  • The car is driven away.
Important
If the wiper arms in service position have been folded up from the windscreen, they must be folded back down onto the windscreen before the activation of wiping, washing or the rain sensor, as well as before driving. This is to avoid scraping the paint on the bonnet.

Topping up washer fluid

Washer fluid is used for cleaning the headlamps and windscreen. Washer fluid with antifreeze must be used when the temperature is under the freezing point.

Note

  • When approx. 1 litre (1 qt) of washer fluid remains in the reservoir, the message Refill washer fluid, level low appears together with the symbol in the driver display.
  • When the Refill washer fluid, level low message together with the symbol appear in the driver display, it is time to refill washer fluid
  • Open the bonnet with the handle in the passenger compartment and then with the handle under the front edge of the bonnet.
  • Open the washer fluid reservoir cap.
  • Washer fluid is filled into the reservoir with the blue cap. The reservoir is used for windscreen washer, rear window washer and headlamp washers.
  • Top up with washer fluid.
  • Close the washer fluid reservoir cap and then close the bonnet.

Prescribed grade: Washer fluid recommended by Volvo – with frost protection during cold weather and for temperatures below freezing point.

Important
Use Volvo genuine washer fluid or equivalent with a recommended pH of between 6 and 8, in working dilution (e.g. 1:1 with neutral water).
Important
Use washer fluid with antifreeze when the temperature is below freezing to avoid the fluid freezing inside the pump, reservoir and hoses.

Volume:

  • Cars with headlamp washing: 5.5 litres (5.8 qts).
  • Cars without headlamp washing: 3.5 litres (3.7 qts).

Replacing windscreen wiper blades

The wiper blades sweep water away from the windscreen. Together with washer fluid, they aim to clean the windscreen and ensure visibility while driving. The wiper blades can be replaced.
Fold up the wiper arm when it is in service position. Service position is activated/deactivated via the centre display when the car is stationary and the windscreen wipers are not switched on.
  1. Set the wiper blade in removal position by angling it out from the arm until a click sound can be heard.
  2. Press and hold the lock button located on the wiper blade mounting.
  3. At the same time, pull the blade straight out parallel with the wiper arm.

Slide in the new wiper blade until the lock button engages.
Angle the blade in towards the arm until a click sound is heard. The blade is then no longer in the removal position and can be moved again.
Check that the wiper blade is firmly installed.
Fold the wiper arm back towards the windscreen.

The wiper blades are different lengths

Note
When replacing the wiper blades, note that they have different lengths. The blade on the driver’s side is longer than on the passenger side.
Automotive Solutions

Recent Posts

VW Jetta Engine Fuse Box Diagram

Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…

8 months ago

VW Jetta Passenger Fuse Box Diagram

Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…

8 months ago

2023 Ford F-150 Lightning Fuse Box Diagram

Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…

2 years ago

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner’s Manual

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…

2 years ago

2023 Land Rover Range Rover Evoque Exiting The Vehicle Owners Manual

2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…

2 years ago

2023 Land Rover Range Rover Evoque Front Seats Owners Manual

2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…

2 years ago