Using a stored setting
A stored setting can be used with the front door either open or closed:
Open front door
Depress one of the memory buttons 1 (2) or 2 (3) with a short press. Power seat, door mirrors and head-up display move and then stop at the positions stored in the selected memory button.
Depress one of the memory buttons 1 (2) or 2 (3) with a short press. Power seat, door mirrors and head-up display move and then stop at the positions stored in the selected memory button.
Closed front door
Hold one of the memory buttons 1 (2) or 2 (3) depressed until seat, door mirrors and head-up display stop in the positions that are stored in the selected memory button.If the memory button is released, the movement of the seat, door mirrors and head-up display will be stopped.
Hold one of the memory buttons 1 (2) or 2 (3) depressed until seat, door mirrors and head-up display stop in the positions that are stored in the selected memory button.If the memory button is released, the movement of the seat, door mirrors and head-up display will be stopped.
Warning
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- Make sure there is nothing under the seats when they are being adjusted.
Note
The stored positions are saved in the active profile.
The stored positions are saved in the active profile.
Storing position for seat, door mirrors and head-up display
- You can store the position for power seat, door mirrors and head-up display in the memory buttons.
- Store two different positions for the power seat, the door mirrors and the head-up display using the memory buttons. The buttons are located on the inside of one of the front doors or both.
- Button M for storing settings.
- Memory button.
- Memory button.
Storing a position
- Adjust seat, door mirrors and head-up display to the desired position.
- Press and hold the M button depressed. The light indicator in the button illuminates.
- Within three seconds, press and hold the 1 or 2 button.
- When the position has been stored in the selected memory button, an acoustic signal can be heard and the light indicator in the M button extinguishes.
- If none of the memory buttons is depressed within three seconds then the M button extinguishes and no storing takes place.
- The seat, the door mirrors or the head-up-display must be readjusted before a new memory can be set.
Note
The stored positions are saved in the active profile.