Store two different positions for the power seat and the door mirrors using the memory buttons. The buttons are located on the inside of either one or both front doors.
- Button M for storing a setting.
- Memory button.
- Memory button.
Storing positions
- Adjust seat and door mirrors to the desired position.
- Press and hold the M button. The indicator light in the button will illuminate.
- Within three seconds, press and hold the 1 or 2 button.
> When the position has been stored in the memory button, an audio signal will sound and the indicator light in the M button will go out.
If none of the memory buttons are pressed within three seconds, the M button will go out and no position will be stored.
The seat or door mirrors must be readjusted before a new memory position can be set.
Using the stored seat and door mirror positions
If the positions for the power seat and door mirrors have been stored, they can be activated using the memory buttons.
Using a stored position
To use a stored position, press and hold one of the memory buttons 1 (2) or 2 (3) until the seat reaches the stored position.
Releasing the memory buttons will stop the movement of the seat and door mirrors.
WARNING
- Because the driver’s seat can be adjusted with the ignition off, children should never be left unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
- Do not adjust the seat while driving.
- The seat should be adjusted so that the brake pedal can be depressed fully. In addition, position the seat as far rearward as comfort and control allow.
- The seat rails on the floor must not be obstructed in any way when the seat is in motion.