Automatic extension and retraction of spoiler
The spoiler is automatically extended from its flush position in the trunk lid when the vehicle reaches a speed of 100 km/h (62 mph). The spoiler is extended when the vehicle’s speed is reduced to 70 km/h (43 mph).
Heavy loads of ice and snow could damage the spoiler. Make sure to keep the bumper clean.
Make sure the spoiler is retracted to its flush position in automatic car washes or when using a high-pressure wash.
Symbols in the instrument panel
A number of messages relating to the active spoiler can be shown in the instrument panel in the event of a fault.
| Symbol | Message | Meaning |
|---|---|---|
| | Spoiler malfunctionStay below 200 km/h or Spoiler malfunctionStay below 125 mph | Something is preventing extension of the spoiler. Make sure that ice or another object is not blocking the spoiler. If you experience any problems, contact Polestar Customer Support. |
| | Spoiler blockedSee Manual | Something is preventing retraction of the spoiler. Make sure that ice or another object is not blocking the spoiler. If you experience any problems, contact Polestar Customer Support. |
Spoiler settings
Extending the spoiler
Button with an upward-facing arrow on the inside of the driver’s door.
- The vehicle must be in at least ignition mode II.
- Press the button to extend the spoiler.
> The indicator light will glow steadily when the spoiler is fully extended.
Retracting the spoiler
- The vehicle must be in at least ignition mode II.
- Press the button to retract the spoiler.
> The indicator light goes out when the spoiler is retracted.
Be aware of the risk of injury when retracting the spoiler at low speeds or at a standstill.