2022 Lucid Air Front Seats
Adjusting the Front Seats
WARNING: Do not adjust the driver’s seat while driving. Doing so increases the risk of collision.
WARNING: Before adjusting a seat, check that the area around the seat is free of obstacles.
WARNING: Do not sit in or operate the vehicle until you adjust all seats and head restraints to their proper position. Failure to adjust seats and head restraints increases the risk of neck injury in the event of a crash.
Front seats can be adjusted using either the seat-mounted switches or the Pilot Panel.
Using the Seat-mounted Switches
- Position
Move the seat forward/backward and adjust the seat’s height and tilt angle up/down. - Backrest
Rotate the switch backward/forward to adjust the angle of the seat back. - Lumbar
Press the up/down buttons to raise/lower the lumbar support, and the left/right buttons to adjust the firmness of the lumbar support.
Using the Pilot Panel
- To adjust the seats using the Pilot Panel, select > SEATS.
- Select the seat you want to adjust using the DRIVER or PASSENGER tabs.
- Select the seat area you want to adjust from the side menu and then use the arrow motion
Correct Seating Position
The seat, head restraint, seat belt, and airbags work together to maximize safety. Using these correctly provides greater protection.
- To reduce the risk of injuries in an accident, follow these instructions:
- The driver and front passenger position their seats so that they can correctly wear the seat belt while being as far away from the front airbags as possible.
- Sit upright, place both feet on the floor, and make sure that the seat back reclines no more than 30 degrees.
- Easily reach the pedals with your feet and slightly bend your arms while holding the steering wheel. The distance between the driver’s chest and the center of the airbag cover should be at least 10 inches (254 mm).
- Grasp the steering wheel on the steering wheel rim. Hold your hands at the 3 o’clock and 9 o’clock positions to reduce the risk of injury to your hands or arms if the airbag deploys.
- Adjust the D ring position to position the shoulder section of the seat belt midway between your neck and your shoulder. Fit the lap section of the belt tightly as low and snug as possible around the hips, not the waist.
WARNING: When the seat is in the reclined position, the shoulder belt and lap belt do not provide proper protection in an accident. You could slip past the shoulder belt, be thrown into the shoulder belt and receive neck or other serious injuries. You could also slide under the lap belt and receive serious internal injuries.
Massage Feature
- Both front seats have a seat massage feature to help prevent muscle fatigue and improve blood circulation when seated for long periods of time.
- To control seat massage programs using the Pilot Panel, select > MASSAGE.
- Select the required seating position using the DRIVER or PASSENGER tab. Select the massage program you want to use from the side menu.
- NOTE: If you previously used the massage feature, the massage feature selects the last used program and intensity.
- Press the START MESSAGE button to activate the seat massage feature.
- Each massage program runs for 20 minutes. A countdown showing the time remaining shows on the screen. To stop the massage program, press the STOP MASSAGE button.
- The intensity of the massage can be increased or decreased by pressing the or icons.
Seat Heating and Ventilation
- Both front seats have integrated seat heaters and ventilation.
- To control seat heating and ventilation using the Pilot Panel, select . Press the corresponding icon to heat or ventilate the desired seat.
You can heat or ventilate the seats at three different levels.
- Press once to operate at the highest level. Three intensity indicators illuminate.
- Press twice to operate at the medium level. Two intensity indicators illuminate.
- Press a third time to operate at the lowest level. A single intensity indicator illuminates.
- Press a fourth time to turn off the selected feature.
Pressing one of the two zones on the seats deactivates heating or ventilation for that Zone.
NOTE: Seat heating and ventilation cannot be used both together. Changing the seat heating to ventilation stops the seat heating and turns on the ventilation. Similarly, changing the ventilation to seat heating stops the ventilation and turns on the seat heating.