The low beam headlights, tail lights and license plate lights will automatically switch On when the ambient light falls below a pre-defined level. The lights will switch Off when the ambient light rises above that level.
NOTE: The lights will switch On whenever the windshield wipers are operating.

Position lights

The position (side marker) lights indicator is displayed on the Cockpit Panel whenever the
position lights are On.

Low beams

The low beam indicator is displayed on the Cockpit Panel whenever the low beams are On.

Daytime running lights

NOTE: The functionality and operation of daytime running lights will vary according to market requirements.
In regions that require the vehicle’s lights to be On even during the day, the daytime running lights will automatically switch On whenever the vehicle is in Drive mode.

Light failure

If the vehicle detects that an exterior light is not working the light failure indicator will be displayed on the Cockpit Panel. This will be accompanied by a message as to which bulb has failed.

Lights on warning

If the exterior lights have been left On, a chime will sound when the driver’s door is opened.

High Beam Headlights

NOTE: The headlight high beams will only operate if the low beams are on.

To turn on the high beam headlights, push the left steering column lever away from you. To cancel, pull the lever towards you.
The high beam indicator is displayed on the Cockpit Panel whenever high beams are On.

Headlight high beam flash

You can flash the headlight high beams by pulling the lever fully towards the steering wheel and releasing it.

Rear Fog Light

NOTE: Regulations concerning the use of fog lights vary from country to country.
The rear fog light is considerably brighter than ordinary taillights and should only be used to help other road users see your vehicle in low-visibility conditions such as fog or heavy snowfall.

Use the left Cockpit Panel to turn the rear fog lamp On or Off.

The rear fog light indicator is displayed on the Cockpit Panel whenever the rear fog light is On.
NOTE: The rear fog light is automatically turned Off each time the vehicle is powered On and will need to be manually turn On if required.

Turn Signals

The turn signals are activated by moving the left steering column lever down to operate the left turn signals, or up to operate the right turn signals.
The turn signals will continue to operate until automatically canceled by the steering wheel, or by returning the lever to the central position. When a turn signal is activated, the corresponding turn signal indicator is displayed on the Cockpit anel. You will also hear a clicking sound when the turn signal is operating.

Lane changes

To signal a lane change, momentarily hold the lever up or down against the spring pressure and then release; the turn signals will flash three times to indicate a lane change.

Hazard Warning Lights

NOTE: The hazard warning lights can be operated even when a key fob is not in the vehicle.

To turn on the hazard warning lights, press the switch located on the overhead console. All turn signals will flash along with the turn signal indicators on the Center Cockpit Panel.
Press the switch again to switch off the hazard warning lights.
NOTE: You should only use hazard warning lights in an emergency to warn other road users of a breakdown or other potential danger. Remember to switch off when the hazardous situation has been resolved.
After a collision
If you are involved in a collision that causes the airbags to be deployed, the hazard warning lights will automatically Switch on.