2022 Land Rover Range Rover Sport Windows
ELECTRIC WINDOWS
If children are carried in the rear seats, the isolator switch should be used to prevent the operation of the windows. If the windows are operated by young children, there is a risk of serious injury or death.
Make sure that you remove the smart key when leaving the vehicle. This prevents unsupervised operation of the windows and sunroof, which may result in an injury.
Wherever possible, remove any snow, ice, dirt, leaves, etc., from the panoramic roof mechanism before closing. Failure to do so may damage the panoramic roof mechanism.
To prevent accidental damage, make sure that any roof rack load will not interfere with the opening of the panoramic roof.
- Front window switches:
To open a window: Press lightly at the front of the switch and release.
To close a window: Pull up lightly at the front of the switch and release.
For one-touch open and close operation, press or pull firmly at the front of the switch and release.
NOTESThe windows operate for 5 minutes after the engine is switched off, as long as none of the doors are opened.
- Rear window switches.
- Panoramic roof switch:
Press lightly at the rear of the switch to tilt the roof. Once tilted, lightly press again to open the roof.
From the fully open position, press lightly at the front of the switch to close to the tilt position, then press lightly again to close fully.
For one-touch open and close operation, press firmly at the front or rear of the switch and release.
NOTESThe panoramic roof will operate for 40 seconds after the ignition is switched off, provided that the front door is not opened.
- Panoramic roof blind switch:
To open the blind: Press lightly at the rear of the switch and release.
To close the blind: Press lightly at the front of the switch and release.
For one-touch open and close operation, press firmly at the front or rear of the switch and release.
The automatic operation of the roof blind can be adjusted via the climate settings screen on the touchscreen display.
When the feature is selected and the doors are locked, the roof blind closes automatically. When the engine is running, the roof blind returns to the previous open position.
ANTI-TRAP PROTECTION
Closing a window or roof blind onto any part of the body can result in serious injury.
Before closing a window or the panoramic roof, make sure that no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system, death or serious injury could occur.
- The anti-trap mechanism does not operate when closing the panoramic roof from the tilted position.
- The panoramic roof can cause serious injury should a body part become trapped.
- Always make sure that the panoramic roof is free from obstructions before closing.
- Anti-trap protection will stop window or panoramic roof movement if an obstruction or resistance is detected.
- Check the window or panoramic roof and its aperture, and remove any obstructions (e.g., ice, etc.).
- If it is still necessary to raise the window or close the panoramic roof, the override procedure is as follows:
- Attempt to close the window or panoramic roof. Anti-trap prevents closure and lowers the window or opens the panoramic roof slightly.
- Within 10 seconds, attempt to raise the window or close the panoramic roof again. Anti-trap prevents closure and lowers the window or opens the panoramic roof slightly.
- Attempt to close the window or panoramic roof for the third time. Hold the button in the close position. Hold until closed.
If this procedure fails to remove the blockage, the window operation may need to be reset. See WINDOW RESET.
The panoramic roof’s anti-trap mechanism works differently and does not require a reset if activated. See PANORAMIC ROOF RESET.
SOLAR ATTENUATING GLASS
The solar attenuating glass windshield filters sunlight passing through a special laminated layer. Electronic devices, such as toll road payment tags or Radio Frequency (RF) ID tags, can be attached at the indicated locations. The locations are on the inside of the windshield. If the tags are located at any other part of a solar attenuating windshield, the electronic scanners may not recognize them. The optimal fixing location is at the top of the windshield, as shown in (1), close to the interior rearview mirror.
The electronic device should be in the size-appropriate location on the driver’s side of the windshield.
Transponders, mounted on the front license mount plinth, can be used as an alternative, dependent on the market and availability.