2023 Land Rover NEW RANGE ROVER HEADPHONES Owner Manual

To disconnect or forget a device:

1. Select the device from the paired list.
2. Select either Disconnect or Remove headphones
   NOTES
   The disconnect option is only available if the headphones are currently connected.
3. The device is no longer visible in the paired list.

HEADPHONES OVERVIEW

Headphones may be supplied for vehicles fitted with rear seat screens.

Operate the headphones as follows:

1. Volume button:

   When in audio mode, apply a short press to the + button to increase the volume. Alternatively, to skip to the next track apply a long press for approximately 1.5 seconds.

   NOTES
   When at maximum volume, the max volume tone will sound.

   When in audio mode, apply a short press to the – button to decrease the volume. Alternatively, to skip to the previous track apply a long press for approximately 1.5 seconds.

2. LED indicator: Displays the status of the headphones. See HEADPHONE CHARGING AND STATUS
3. Power button:

   To power on the headphones, long press for approximately 2 seconds. A tone sounds accompanied by the LED status indicator. See HEADPHONE CHARGING AND STATUS.

   To power off the headphones, long press for approximately 2 seconds. A tone sounds accompanied by the LED status indicator. See HEADPHONE CHARGING AND STATUS.

   When in audio mode, a short press will enable you to play or pause the audio.

   NOTES
   Without a device connected, the headphones power off automatically after 5 minutes.
4. USB-C input: Used to charge the headphones. See HEADPHONE CHARGING AND STATUS

HEADPHONE PAIRING AND RESET

The headphones supplied with the vehicle can pair with up to eight devices. The first device paired with the headphones becomes the default and automatically connects when the headphones and device are powered on. Connecting to a device other than the default must be done via manual pairing.

To change the default device, perform a factory reset or clear the paired list on the device.

To manually pair the headphones supplied with the vehicle:

1. Power on the headphones.
2. Press and hold the power button for approximately 5 seconds, the headphones are now discoverable. A tone sounds accompanied by the LED status indicator. See HEADPHONE CHARGING AND STATUS
3. Use the device’s Bluetooth connection to search for the headphones and follow the device instructions to pair. To pair with the vehicle, follow the instructions on pairing via the touchscreen. See PAIRING AND CONNECTING USING THE TOUCHSCREEN
4. A tone sounds when pairing is complete.
   NOTES
   The device does not find tone sounds if pairing times out.

To reset the default device and check the status:

1. Press the power button for 3 seconds, and release the button when the LED indicator flashes red.
2. Check the status of the LED indicator:

   If the LED flashes red and blue, a default device is not stored.

   If the LED flashes blue, a default device is stored.

3. To clear a stored device, press and hold the volume + and – buttons until the headphones power off.

HEADPHONE CHARGING AND STATUS

Charging

When the headphones have less than 20% power, the low battery tone sounds. The LED indicator also illuminates red for a duration of 1 second per minute.

To charge the headphones:

• Connect the supplied charging cable to the USB-C input on the headphones.
• Connect the other end of the USB-C charging cable to an appropriate power source. See AUXILIARY POWER SOCKETS.
• The LED indicator illuminates red to confirm charging is in progress.
• The LED indicator illuminates blue once charging is complete.

LED status and voice prompts