Do not start the engine, or drive the vehicle, if leaked fluid could possibly make contact with a hot surface. Any leaked fluid coming into contact with a hot surface, such as the exhaust, could result in combustion. Seek qualified assistance immediately.

A number of simple checks and routine maintenance must be carried out at regular intervals. See WEEKLY CHECKS.

2.0L GASOLINE ENGINE:

Washer fluid reservoir filler cap.
Brake fluid reservoir cap.
Engine coolant reservoir filler cap.
Engine oil level dipstick.
Engine oil filler cap.

3.0L GASOLINE ENGINE:

Washer fluid reservoir filler cap.
Brake fluid reservoir cap.
Engine coolant reservoir filler cap.
Engine oil level dipstick.
Engine oil filler cap.

CHECKING THE ENGINE OIL LEVEL

CAUTION

Check the engine oil weekly. If any significant or sudden drop in the engine oil level is noted, seek qualified assistance.

CAUTION

Never allow the engine oil level to fall below the lower mark on the dipstick or the oil level indicator.

CAUTION

If the instrument panel displays the message ENGINE OIL PRESSURE LOW, stop the vehicle as soon as it is safe to do so. Allowing the engine to continue running with low oil pressure may cause the engine to seize. Seek qualified assistance immediately. Do not start the engine until the cause has been rectified.

Check the engine oil level frequently. Top up, as required, using the correct grade for the engine.

ENGINES WITH A DIPSTICK:

NOTES

The graphic shown above is for illustrative purposes only.

The dipstick features minimum and maximum marks in order to help determine the oil level present in the engine. The marks can take the form of holes, lines, or a hatched area.

CAUTION

The dipstick on 2.0L gasoline engines features a lug to aid correct fitment. Make sure the lug is correctly aligned with the groove in the dipstick tube. Failure to do this could result in the dipstick not fitting correctly and oil escaping from the engine.

Before checking the engine oil level, make sure that:

The vehicle is stationary and the Electric Parking Brake (EPB) is applied.
The vehicle is on level ground.
The engine oil is cold.
NOTES

If it is necessary to check the oil level when the engine is hot, switch off the engine. Let the vehicle stand for 5 minutes to allow the oil to drain back into the sump. Do not start the engine.

The oil level can then be checked as follows:

Withdraw the dipstick and wipe the blade clean with a lint-free cloth.
Fully reinsert the dipstick and withdraw again to check the oil level.

If the oil level lies within the hatched portion on the dipstick blade, do not add any more oil.
There is no requirement to top-up the oil unless the oil is at or below the lower mark.
If the oil level is below the lower mark, add 1 L of oil. Recheck the level and add more oil, if necessary.
Once the oil has reached the correct level on the dipstick, wait 5 minutes and recheck.

ENGINES WITHOUT A DIPSTICK:

Engines without a dipstick feature an electronic monitoring system. The engine oil level is not monitored when the engine is running, or when the vehicle is in motion.

Before checking the oil level, make sure that:

The vehicle is stationary and the Electric Parking Brake (EPB) is applied.
The vehicle is on level ground.
The engine oil has reached its normal working temperature (oil is hot).
The engine has been switched off for 10 minutes. The system does not give an accurate reading until the oil level has stabilized.

The oil level can then be checked as follows:

Switch on the vehicle’s ignition. Do not start the engine. See SWITCHING ON THE IGNITION.
Select Oil Level from the Vehicle Info menu. See INSTRUMENT PANEL MENU OPERATION.

The instrument panel displays the engine oil level indicator.

The indicator displays an indication of the oil level. Messages to the right of the indicator advise of any action to be taken.

Message	Action
OK	No action is required.
Overfilled	Seek qualified assistance immediately. Do not drive the vehicle as this will cause serious damage to the engine.
Low	Add 1.6 U.S. quarts (1.5 liters) of oil. Recheck the level.
Critically Low	Seek qualified assistance immediately.
Add XX Quarts	Add the advised quantity of oil to the engine. Recheck the level.
Not Available	The oil level is stabilizing. Switch off the ignition. Wait 10 minutes, then recheck the oil level display.
ENGINE OIL LEVEL MONITOR SYSTEM FAULT	Seek qualified assistance immediately.

TOPPING UP THE OIL

CAUTION

The vehicle’s warranty may be invalidated if the damage is caused by using oil that does not meet the required specification. See LUBRICANTS AND FLUIDS.

CAUTION

Before driving off-road, top up the engine oil level to the maximum mark on the engine oil level dipstick. Failure to do so could result in an insufficient oil level when driving at certain angles off-road, which could cause damage to the engine.

CAUTION

Failure to use an oil that meets the required specification could cause excessive engine wear, a build-up of sludge and deposits, and increased pollution. A resultant cause could be engine failure.

CAUTION

Overfilling with oil could result in severe engine damage. Oil should be added in small quantities and the level rechecked to make sure the engine is not overfilled.

CAUTION

The use of the correct oil specification is essential. Make sure the oil is suitable for the climatic conditions in which the vehicle is to be operated.

Turn the oil filler cap counter-clockwise to remove.
For engines with a dipstick:

Add oil to maintain the level between the MIN and MAX marks on the dipstick.
For engines with an electronic monitoring system:

Add oil, as indicated by the engine oil level indicator messages in the instrument panel.
Clean up any oil spilled during topping up.
Check the oil level again after 5 minutes.
To refit the oil filler cap, turn the cap clockwise until resistance is felt.

CHECKING THE COOLANT LEVEL

CAUTION

Running the engine without coolant causes serious engine damage.

CAUTION

If persistent coolant loss is noticed, seek qualified assistance immediately. Check the coolant reservoir level at least every week. Check more frequently in high mileage or arduous conditions. Always check the level when the system is cold.

Make sure the coolant level remains between the MIN and MAX indicator marks, located on the side of the expansion tank. If the coolant level has dropped suddenly, or by a large amount, arrange for the vehicle to be examined by qualified personnel. Consult a retailer/authorized repairer as soon as possible.

TOPPING UP THE COOLANT

WARNING

Never remove the coolant reservoir filler cap when the engine is hot. Escaping steam or scalding water could cause serious personal injury. Unscrew the filler cap slowly, allowing the pressure to escape before removing completely.

WARNING

Antifreeze is highly flammable. Do not allow antifreeze to come into contact with open flames or other sources of ignition, e.g., a hot engine. A fire may result.

WARNING

Antifreeze is poisonous and can be fatal if swallowed. Keep containers sealed and out of the reach of children. If consumption is suspected, seek medical attention immediately.

WARNING

If the fluid comes into contact with the skin or eyes, rinse immediately with plenty of water. Failure to do so may result in serious injury.

CAUTION

When traveling in territories where the water supply contains salt, always make sure to carry a supply of fresh (rain or distilled) water. Topping up with salt water causes serious engine damage.

CAUTION

The use of non-approved antifreeze has an adverse effect on the engine’s cooling system and, therefore, engine durability. See LUBRICANTS AND FLUIDS.

CAUTION

Antifreeze damages painted surfaces. Soak up any spillage with an absorbent cloth immediately, and wash the area with a mixture of car shampoo and water.

CAUTION

Do not use any anti-leak products in the cooling system, as it causes damage to the vehicle. Antifreeze contains important corrosion inhibitors. The antifreeze content of the coolant must be maintained at 50% to 60% all year round, not just in cold conditions. To make sure the anti-corrosion properties of the coolant are maintained, the antifreeze content should be checked once a year. The antifreeze should be completely replaced every 10 years, regardless of the distance traveled. Failure to do so may cause corrosion of the radiator and engine components. The specific gravity of a 50% antifreeze solution at 68°F (20°C) is 1.068 and protects against frost down to -40°F (-40°C).

To top up the coolant:

Rotate the coolant reservoir filler cap counter-clockwise and remove.
Top up to the MAX indicator mark on the side of the coolant reservoir. Use a mixture of 50% water and 50% antifreeze. See LUBRICANTS AND FLUIDS.
CAUTION

Make sure that the correct mixture of water and antifreeze is used. Failure to do so may cause damage to the vehicle. See LUBRICANTS AND FLUIDS.

NOTES

In an emergency, and only if the approved antifreeze is unavailable, top up the cooling system with clean water. Be aware of the resultant reduction in frost protection. Do not top up or refill with conventional antifreeze formulations. If in doubt, consult a qualified technician.
To refit, the coolant reservoir filler cap, rotate the filler cap clockwise until the cap’s ratchet clicks at least three times.

CHECKING THE BRAKE FLUID LEVEL

WARNING

Seek qualified assistance immediately if brake pedal travel is unusually long, or if there is any significant loss of brake fluid. Driving under such conditions could result in extended stopping distances or complete brake failure.

WARNING

Brake fluid is highly toxic. Keep containers sealed and out of the reach of children. If accidental consumption of fluid is suspected, seek medical attention immediately.

WARNING

If the fluid comes into contact with the skin or eyes, rinse immediately with plenty of water.

WARNING

Brake fluid is highly flammable. Do not allow brake fluid to come into contact with open flames, a hot engine, or other sources of ignition. A fire may result.

WARNING

Do not drive the vehicle with the fluid level below the MIN mark.

If the quantity of fluid in the brake reservoir drops below the recommended level, a red warning lamp in the instrument panel illuminates. See BRAKE (RED).

NOTES

If the warning lamp illuminates while the vehicle is being driven, gently apply the brakes to stop the vehicle, as soon as safety permits. Check and top up the fluid level, if necessary. With the vehicle on level ground, check the fluid level at least every week. Check more frequently in high mileage or arduous operating conditions.

The driver’s side under-hood cover must be removed to check the brake fluid level. See FLUID FILLER LOCATIONS and UNDER-HOOD COVERS REMOVAL. Check the brake fluid reservoir level. The level should be between the MIN and the MAX marks.

NOTES

The fluid level may drop slightly during normal use, as a result of brake pad wear. The fluid level should not be allowed to drop below the MIN mark.

TOPPING UP THE BRAKE FLUID

CAUTION

Always use brake fluid that has the correct specification. See LUBRICANTS AND FLUIDS.

CAUTION

Brake fluid damages painted surfaces. Soak up any spillage with an absorbent cloth immediately. Wash the area with a mixture of car shampoo and water.

CAUTION

Only use new fluid from an airtight container. Fluid from open containers or fluid previously bled from the system, would have absorbed moisture. Contaminated fluid adversely affects performance, and must not be used.

CAUTION

Do not top up the brake fluid to the maximum mark unless the brake pads have been replaced. If unsure, seek qualified assistance.

To top up the brake fluid:

Clean the brake fluid reservoir and the filler cap before removing, it to prevent dirt from entering the reservoir.
Rotate the reservoir filler cap counter-clockwise and remove it.
Top up the reservoir to at least the minimum mark.
Rotate the reservoir filler cap clockwise to refit.
Refit the under-hood cover. See UNDER-HOOD COVERS REFITTING.

CHECKING THE WASHER FLUID LEVEL

WARNING

Some windshield washer products are flammable, particularly if high or undiluted concentrations are exposed to sparking. Do not allow the windshield washer fluid to come into contact with exposed flames or sources of ignition, as this can cause a fire or explosion.

WARNING

If the vehicle is operated in temperatures below 40°F (4°C), use a windshield washer fluid with frost protection. In cold weather, failure to use a windshield washer fluid with frost protection could result in impaired vision and increase the risk of a vehicle crash.

CAUTION

Do not use antifreeze or vinegar and water solution in the windshield washer reservoir. Antifreeze damages painted surfaces, while vinegar can damage the windshield washer pump.

CAUTION

Body panels may suffer discoloration as a result of windshield washer fluid spillage. Take care to avoid spillage, particularly if an undiluted or high concentration is being used. If spillage occurs, wash the affected area immediately with water.

CAUTION

Only use approved windshield washer fluid.
The washer fluid reservoir supplies the windshield, rear window, and headlight washer jets.
Check and top up the reservoir level at least every week. Always top up with windshield washer fluid to prevent freezing.
Operate the washer controls periodically to check that the nozzles are clear and properly directed.

TOPPING UP THE WASHER FLUID

The washer fluid reservoir is located under the hood on the right side of the vehicle. See FLUID FILLER LOCATIONS.

To top up the washer fluid:

Clean the filler cap before removing, it to prevent dirt from entering the reservoir.
Remove the filler cap.
Top up the reservoir until the fluid is visible in the filler neck.
Replace the filler cap.

Cold climate vehicles also feature a supplemental washer reservoir. The same care points, described above, should be applied to vehicles fitted with a supplemental washer reservoir.

NOTES

On vehicles fitted with a supplemental washer reservoir, always check and top up the main reservoir first.

Automotive Solutions