Make sure you remove the smart key when leaving the vehicle. Removing the smart key from the vehicle prevents unsupervised operation of the windows, which may result in an injury.
To operate the windows:
Briefly press a switch fully down, and release to fully open a window. Pressing or pulling a switch again stops window movement. The windows operate for 5 minutes after the engine is switched off, as long as none of the doors are opened.
Rear windows have a short drop feature for passenger comfort. The first press of a switch lowers the window a short distance to give a flow of air. A second press lowers the window to its full extent.
If a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 1 inch (25 mm) eliminates the condition.
If children are carried in the rear seats, the isolator switch should be used to prevent the operation of the windows and doors. If the windows or doors are operated by young children there is a risk of serious injury or death.
Roof blind open and close switch:
Closing a window or roof blind onto any part of the body can result in serious injury.
Before closing a window or the roof blind, make sure no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system, death or serious injury could occur.
Anti-trap protection is designed to stop window or roof blind movement if an obstruction or resistance is detected. Check the window or roof blind, and its aperture, and remove any obstructions, e.g., ice, etc.
If it is still necessary to raise the window, the override procedure is as follows:
If this procedure fails to remove the blockage, or if the windows do not operate correctly, the window’s operation may need to be reset. See WINDOW RESET.
The solar attenuating glass windshield filters sunlight passing through a special laminated layer.
Electronic actuating cards, such as toll road payment cards or Radio Frequency (RF) ID tags, can be fixed at dedicated locations. The locations are on the inside of the windshield. If the cards are located at any other part of a solar attenuating windshield, the electronic scanners may not recognize them. The optimal fixing location is at the top of the windshield, as shown in (1), close to the interior rearview mirror.
The electronic actuating card should be in the size-appropriate location on the driver’s side of the windshield.
Transponders, mounted on the front license plate plinth, can be used as an alternative, dependent on the market and availability.
Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…
Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…
Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…
2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…
2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…
2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…