2022 Land Rover Discovery Sport Vehicle Battery
BATTERY WARNING SYMBOLS
Do not allow open flames or other sources of ignition near the battery, as the battery may emit explosive gases.
Make sure, when working near or handling the battery, that suitable eye protection is worn, to protect the eyes from acid splashes.
To prevent the risk of injury, do not allow children near the battery.
Be aware that the battery may emit explosive gases.
The battery contains acid which is extremely corrosive and toxic.
Consult the Owner’s Handbook for information, before handling the battery.
CALIFORNIA PROPOSITION 65 SECOND WARNING STATEMENT
Batteries, Battery posts, terminals, and related accessories contain lead and lead compounds, and other chemicals are known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
BATTERY CARE
If swallowed, battery fluid can be fatal. Seek medical assistance immediately.
Do not allow battery fluid to contact with skin or eyes. Battery fluid is both toxic and corrosive which can result in severe injuries. If battery fluid comes into contact with eyes, skin, or clothes, remove the affected clothing and flush the skin or eyes with plenty of water. Seek medical assistance immediately.
Do not connect any 12-volt equipment directly to the battery terminals. Doing so may cause a spark, which can result in an explosion.
The vent pipe must be in place at all times when the battery is connected to the vehicle. Make sure the vent pipe is clear of obstructions and not kinked. Failure to do so may cause a pressure build-up in the battery, potentially resulting in an explosion.
Do not expose the battery to an open flame or spark as the battery produces explosive, flammable gas.
Never jump-start, boost charge, or try to start a vehicle with a frozen battery. Doing so can result in an explosion.
To prevent the chance of an electric shock, remove all metal jewelry before working on or near the battery. Never allow metal objects or vehicle components to come into contact with the battery terminals.
Do not allow battery fluid to come into contact with fabrics or painted surfaces. If battery fluid comes into contact with any surface, the surface should be washed down immediately with plenty of clean water.
This vehicle is fitted with an Absorbed Glass Matt (AGM) battery.
AGM batteries are sealed for life and require no maintenance.
Do not attempt to open or remove the top from an AGM battery.
CONNECTING JUMP LEADS
Remove all metal jewelry before working on, or near, a battery or boost terminals. Never allow metal objects or vehicle components to come into contact with the battery or boost terminals. Metal objects can cause sparks or short circuits, resulting in an explosion.
Do not allow the battery posts or terminals to come into contact with the skin. Battery posts and terminals contain lead and lead compounds that are toxic. Always wash your hands thoroughly after handling the battery.
Do not expose any battery to an open flame or spark, as the battery produces explosive, flammable gas.
Never jump-start (boost), charge, or try to start a vehicle with a frozen battery. Doing so can result in an explosion.
Rotating parts of the engine can cause serious injury. Take extreme care when working near rotating parts of the engine.
Before attempting to start the vehicle, make sure that the Electric Parking Brake (EPB) is applied, or suitably chocks the wheels. Make sure that Park (P) or neutral is selected.
Suitable eye protection must be worn when working in the area of a battery.
During normal use, batteries emit explosive gas sufficient to cause severe explosions and are capable of causing serious injury. Keep sparks and open flames away from the battery.
Make sure there is no physical contact between the donor and disabled vehicles, other than the jump leads.
Make sure that any battery or starting aid is a 12-volt device.
Disconnect the jump leads before operating any electrical equipment.
Make sure the jump leads being used are of high quality, in good condition, and are rated to the engine capacity of both vehicles. Incorrectly rated jump leads may not supply sufficient power to the disabled vehicle’s battery and may overheat when attempting to start the vehicle.
Before connecting the jump leads to the disabled vehicle’s boost point terminals, make sure the donor vehicle’s boost point connections are correct. Also, make sure that all electrical equipment has been switched off.
To connect the jump leads:
- Connect the positive (red) jump lead to the recommended positive (+) boost terminal on the donor vehicle.
NOTES
Refer to the donor vehicle’s Owner’s Handbook for the recommended positive boost terminal.
- Connect the other end of the positive (red) jump lead to the positive (+) battery terminal on the disabled vehicle.
- Connect the negative (black) jump lead to the recommended negative (–) boost terminal on the donor vehicle.
NOTES
Refer to the donor vehicle’s Owner’s Handbook for the recommended negative boost terminal.
- Connect the other end of the negative (black) jump lead to the ground point on the disabled vehicle, as illustrated.
NOTES
Check that all cables are clear of any moving components and that all four connections are secure.
- Start the engine of the donor vehicle and allow it to idle for 10 minutes.
- Start the engine of the disabled vehicle.
NOTES
If the vehicle fails to start, repeat step 5 for 20 minutes. If the vehicle still fails to start, seek qualified assistance.
NOTESDo not switch on any electrical circuits on the disabled vehicle until after the jump leads are removed.
- Allow both vehicles to idle for 20 minutes.
- Switch off the donor vehicle.
- Disconnect the negative (black) jump lead from the previously disabled vehicle.
- Disconnect the negative (black) jump lead from the donor vehicle.
- Disconnect the positive (red) jump lead from the previously disabled vehicle.
- Disconnect the positive (red) jump lead from the donor vehicle.
CONNECTING A STARTING AID
To start the vehicle using a starting aid or a booster battery, carry out the following:
- Connect the positive (red) jump lead to the positive (+) battery terminal of the discharged battery.
- Connect the negative (black) jump lead to the vehicle’s ground point.
- Switch on the starting aid.
- Start the engine and allow it to idle.
- Disconnect the negative (black) jump lead from the vehicle’s ground point.
- Switch off the starting aid.
- Disconnect the positive (red) jump lead from the battery terminal of the vehicle.
REMOVING THE VEHICLE BATTERY
Switch the ignition off before disconnecting the battery terminals. Failure to do so may lead to an electrical shock, resulting in injury.
Always disconnect the negative terminal first and reconnect last. Failure to do so may lead to an electrical shock, resulting in injury.
Use caution when lifting the battery out of, or into, the vehicle. It is heavy and may cause injury when lifting, or if dropped.
Do not tip the battery when lifting or moving it. Tilting the battery more than 45 degrees may damage the battery, and may cause the battery fluid to leak out. Battery fluid is highly corrosive and toxic and may cause serious injury.
Battery disconnection, removal, and replacement should be carried out only by qualified personnel. Consult a retailer/authorized repairer. An unqualified person may cause damage to the vehicle.
CHARGING THE VEHICLE BATTERY
Make sure to use the correct type and rating of the charger. Using an unsuitable charger may damage the battery, and could cause the battery to explode. An explosion may lead to serious injury or death.
Charging the battery can produce highly explosive and flammable gas. Always charge the battery in a well-ventilated area away from any open flames, sparks, or other ignition sources. Failure to do so may lead to an explosion, potentially resulting in serious injury or death.
Battery disconnection, removal, and replacement should be carried out only by qualified personnel. Consult a retailer/authorized repairer. An unqualified person may cause damage to the vehicle.
REPLACING THE VEHICLE BATTERY
Battery disconnection, removal, and replacement should be carried out only by qualified personnel. Failure to do so may result in serious injury or death. Consult a retailer/authorized repairer.
Only fit a battery of the same type and rating. Fitting an incorrect battery may result in a fire and injury, or damage to the electrical system. If in doubt when fitting a battery, seek qualified assistance.
When refitting the battery make sure that no metal objects, or vehicle components, come into contact with the battery terminals. Metal objects can cause sparks or short circuits, potentially resulting in an explosion.
Switch the ignition off before disconnecting the battery terminals. Failure to do so may lead to an electrical shock or an explosion, potentially resulting in serious injury or death.
Always disconnect the negative terminal first and reconnect last. Failure to do so may cause a pressure build-up in the battery, potentially resulting in an explosion. An explosion may cause serious injury or death. If the vehicle’s battery requires replacement, consult a retailer/authorized repairer.
Used batteries must be disposed of correctly, as batteries contain a number of harmful substances. Seek advice on disposal from a retailer/authorized repairer or the local authority.
EFFECTS OF DISCONNECTING
Disconnecting the battery can affect a number of vehicle systems, especially if there is insufficient battery power before disconnection. For example, the alarm may trigger, depending on its state when the battery is disconnected. If the alarm does sound, use the smart key, in the normal way, to disarm the security system. The windows may need recalibrating to operate correctly.
After reconnecting the battery, a number of systems may need to be reset.
BATTERY MONITORING SYSTEM
Only start the engine if it is safe to do so. Failure to do so may lead to a collision, potentially resulting in serious injury or death. The Intelligent Power System Management (IPSM) continuously monitors the condition of the main vehicle battery. If excessive battery discharge occurs, the system begins to shut down non-essential electrical systems in order to protect the battery. If the IPSM calculates that the battery’s condition is not within the set parameters, there are two levels of action that can be taken. Both levels have an accompanying message on the touchscreen, and in the case of the low battery warning, in the instrument panel.
- Energy Management: Is displayed in the instrument panel if the engine is not running and system features are causing excessive battery discharge. After 10 minutes, the IPSM begins shutting down the vehicle’s systems. Normal system operation resumes when the engine is started.
- Low battery – Please start the engine: Is displayed on the touchscreen and in the instrument panel, if the engine is not running. After 10 minutes, the IPSM begins shutting down the vehicle’s systems. Normal system operation resumes when the engine is started.
If the instrument panel displays Low Battery – Please Start Engine, and drive the vehicle to allow the battery to recover to an acceptable level. Drive the vehicle for at least 30 minutes in temperatures above 32°F (0°C), or at least 60 minutes if the temperatures are below 32°F (0°C). If normal system operation does not resume when the engine is switched back off, the battery may not have been sufficiently charged. If safe to do so, restart the engine. If problems still exist, contact a retailer/authorized repairer.