Make sure the following warnings have been read and fully understood before using the phone features. Failure to use the phone features safely could result in an accident, leading to serious injury or death.
Do not adjust the touchscreen controls, or allow the system to distract the driver, while the vehicle is moving.
Make sure the relevant safety warnings and cautions have been read and understood before operating the touchscreen. See TOUCHSCREEN SAFETY.
Switch off the phone in areas with a high explosion risk, e.g., filling stations, fuel storage areas, or chemical factories. Further high explosion risks are found where the air contains fuel vapor, chemicals, or metal dust. The phone could trigger an explosion or cause a fire.
Always store the phone securely. In an accident, loose items can cause injury.
The functioning of cardiac pacemakers or hearing aids may be impaired when the phone is in use. Check with a doctor or the device’s manufacturer whether any such devices that the vehicle’s occupants are using are sufficiently protected against high-frequency energy.
Even when using the Bluetooth® wireless technology hands-free feature, using the phone while driving is dangerous. The use of a phone diverts the driver’s attention from the traffic situation. When using the phone, stop at an appropriate place where other vehicles are not endangered or inconvenienced.
Drivers should talk on the phone only when it is safe to do so and when such use does not distract the driver from the road.
Drivers should never text messages, access social media, check emails, or search the internet while driving. Using any of these features while driving diverts attention from the road. The Health Industry Manufacturers’ Association recommends that a minimum separation of 9 in (22 cm) is maintained between a wireless phone antenna and a pacemaker. The recommendation is to avoid potential interference with the pacemaker. The recommendations are consistent with the independent research, and recommendations of, Wireless Technology Research.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
The touchscreen displays the recent call list in the order that the calls were recorded. If this information is not available on the connected phone, the recent call list displays as sent from the phone. Some phones may arrange the list in another order.
The system removes duplicate entries of the same call type from the same caller. For example, multiple calls from the same caller are reduced to one call.
The phone system can be operated and viewed via the touchscreen or instrument panel. See TOUCHSCREEN HOME MENU and INSTRUMENT PANEL MENU OPERATION.
To access the phone features, a phone must be paired with the vehicle. Further information on pairing a phone can be found in the relevant section of the Owner’s Handbook. See PAIRING AND CONNECTING USING THE PHONE.
To access the phone screen, touch the phone icon on the home screen. See TOUCHSCREEN HOME MENU.
To access the phone screen in the instrument panel, press the O icon to display the instrument panel menu. Search Phone and press the O icon. For further information, please refer to the relevant section of the Owner’s Handbook. See INSTRUMENT PANEL MENU OPERATION.
The phone system can also be operated via voice commands. Further information on voice control can be found in the relevant section of the Owner’s Handbook. See USING VOICE CONTROL.
A phone can also be charged using a wireless charger. For further information, please refer to the relevant section of the Owner’s Handbook. See WIRELESS CHARGER.
The availability and functionality of MESSAGES depend on the specification of the vehicle and the market in which the vehicle is being used.
The availability of MESSAGES depends on the handset used and the settings on the mobile device.
The touchscreen displays the recent call list in the order that the calls were recorded. If this information is not available on the paired phone, the recent call list displays as sent from the phone. Some phones may arrange the list in another order.
Please refer to the Land Rover website at: www.landrover.com for a list of compatible phones.
The Bluetooth® wireless technology devices listed have been tested for compatibility with Jaguar Land Rover vehicles. Performance varies, based on the phone’s software version, battery condition, coverage, and the network provider. Phones are warranted by the phone manufacturer, not by the vehicle manufacturer.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
The process of pairing and connecting with the vehicle, from the phone, varies depending on the type of phone used.
Pairing and connecting a phone for the first time:
Some phones require the Bluetooth device pairing to be set as authorized or trusted, in order to automatically connect. Refer to the phone’s operating instructions for further information.
To pair an additional phone:
Paired phones have the option to be used as a phone, media devices, or both. To select a device type:
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
When more than two calls, e.g., a conference call, are active on the phone when connecting to the vehicle’s phone system, the calls are maintained. However, a maximum of two call details are displayed. When more than two calls are in progress when connecting, any calls that are not active, i.e., on hold or incoming, are rejected.
Two calls can be taken on the same phone. Notification is given when a second call is received. When accepting a second call, the first call is automatically put on hold.
Alternatively, a second call can be dialed from the displayed screen options. From the screen options:
When there are two separate calls, the hold icon changes to a swap icon. Touch the swap icon, or the contact’s name or number, to swap between the current call and the call on hold. See PHONE SYSTEM ICONS.
Touch and hold the end call icon to end the current call and return to the remaining call. Touch the end call icon to end both calls. See PHONE SYSTEM ICONS.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY. If two calls are in progress on the same phone, both calls can be merged into one conference call. Select the displayed merge call icon. See PHONE SYSTEM ICONS.
Depending on the part of the phone system in use, the following icons display on the touchscreen:
Call icon: Touch to send or accept a call.
End call icon: Touch to end or reject a call.
Hold call icon: Touch to hold a call. Touch again to return the call.
Add call icon: Touch to make a second phone call.
Swap call icon: Touch to swap between connected calls.
Merge call icon: Touch to merge two connected calls into a conference call.
Handset icon: Touch to switch the call to the phone handset.
Message icon: Touch to send or read a message.
Bin icon: Touch to delete a contact.
Mute icon: Touch to mute the microphone and initiate privacy mode. While selected, the caller cannot hear the conversation.
Phone signal strength indicator.
Phone battery level indicator.
Swap phone icon: Touch to change the phone.
Search contacts icon: Touch to search for contacts.
Recent icon: Touch to view a list of recent calls.
Voicemail icon: Touch for direct call to receive voicemails.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
The user must scroll through a contact list by using the touchscreen scroll bar. See PHONE SYSTEM OVERVIEW.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY. While a phone call is active, rotate the media system’s volume control to adjust the call volume. Alternatively, adjust via the steering wheel controls. See MEDIA CONTROLS and STEERING WHEEL PHONE CONTROLS. If the media system is in use when a phone call is active, the media system source is muted for the duration of the call.
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
Contacts stored in the memory of a paired phone can be automatically downloaded to the vehicle’s contacts list. The contact list is downloaded each time the phone is connected to the system. See PAIRING AND CONNECTING USING THE PHONE.
Certain phones store their contacts in two different areas: the SIM card and the phone’s memory. The vehicle’s system accesses only those numbers stored in the phone’s memory.
To access contacts via the touchscreen:
To display the entire list, use the scroll bar.
To access contacts via the instrument panel:
If the phone supports contact cards, contact information can be displayed in the vehicle’s contacts list.
The order in which the contacts list is displayed can be changed as follows:
Make sure the relevant safety warnings have been read and understood before operating the phone features. See PHONE SAFETY.
The message feature is not compatible with all phones. For further information, please refer to the Land Rover website at: www.landrover.com.
The availability and functionality of MESSAGES depend on the specification of the vehicle and the market in which the vehicle is being used.
The touchscreen-only displays messages to the selected paired device.
The touchscreen does not display the MESSAGES soft key if the user declines access via the phone to download messages.
To access text messages via the touchscreen a phone must be paired with the vehicle. For further information on pairing a phone, refer to the relevant section of the Owner’s Handbook. See PAIRING AND CONNECTING USING THE PHONE.
When receiving an incoming text message, the touchscreen displays a pop-up notification.
A pop-up notification displays the following options:
Call icon: Touch to call the sender of the text message.
Read Out soft key: Touch for the text message to be read out as an audio message.
To access the MESSAGES list on the touchscreen:
Call.
Read Out.
Reply: Provides a list of templates that the user can reply with, e.g., I will call you back or I will be there soon. Select the required reply. Alternatively, the user can edit and create a message template to reply with.
The Reply option is only available when the vehicle is stationary.
The user can access received messages and send replies via voice commands. For further information, refer to the relevant section of the Owner’s Handbook. See USING VOICE CONTROL.
To display the message settings:
The following options are available:
Android Auto™ is compatible with Android phones running v5.0 (Lollipop) and above.
Google™, Android™, Android Auto™, Google Play™, and other related marks and logos are trademarks of Google LLC.
Android Auto is a feature designed to give the user access to core phone features while driving, e.g., music, phone calls, Google voice support, messaging, and navigation, with safety in mind. The feature is designed to minimize distraction so that the user can remain focused on the road.
To access Android Auto, the user needs an Android phone running 5.0 (Lollipop) or higher.
Android Auto is designed to work using voice control as much as possible. A Google voice session can be started either from the Android Auto screen or through a long press of the steering wheel voice button.
A short press of the voice button will start a vehicle’s native voice control session. See USING VOICE CONTROL. For further information on Android Auto please visit www.android.com/auto.
Apple CarPlay® is only compatible with an iPhone® 5 and above running iOS 7.1 and above.
Apple® and iPhone® are registered trademarks of Apple Inc., registered in the US and other countries. App Store® is a service mark of Apple Inc.
Apple CarPlay is a feature designed to give the user access to core iPhone features while driving, e.g., music, phone calls, Siri, messaging, and navigation with safety in mind. The feature is designed to minimize distraction so that the user can remain focused on the road.
To access Apple CarPlay, the user needs an iPhone 5 and above running iOS 7.1 and above.
Apple CarPlay is designed to work using voice control as much as possible. A Siri voice session can be started either from the Apple CarPlay screen or through a long press of the steering wheel voice button.
A short press of the voice button will start a vehicle’s native voice control session. See USING VOICE CONTROL. For further information on Apple CarPlay please visit the Apple website at: www.apple.com.
The product contains commodities, technology, or software exported from the United States (US) in accordance with the Export Administration regulations. Diversion contrary to US or Canadian law is prohibited.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
The device complies with Industry Canada Standard IC-RSS-210 and IC-RSS-251.
Operation is subject to the following two conditions:
The equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC Radio Frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC Radio Frequency (RF) Exposure rules. The equipment has very low levels of RF energy that is deemed to comply without Maximum Permissive Exposure evaluation (MPE).
But it is desirable that it should be fitted and operated with at least 8 in (20 cm) and more between the radiator and the person’s body, excluding extremities: hands, wrists, feet, and ankles.
USA FCC ID: A269ZUA130.
Canada IC: 700BIAM2101.
Changes or modifications, not expressly approved by the party responsible for the compliance, could void the user’s authority to operate the equipment.
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The equipment limits are designed to provide reasonable protection against harmful interference in a residential fitment. The equipment generates, uses, and can radiate Radio Frequency (RF) energy. When not fitted and used in accordance with the instructions, the equipment may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular fitment. If the equipment causes harmful interference to radio or television reception when turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:
Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…
Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…
Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…
2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…
2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…
2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…