Make sure the following guidance has been read and fully understood before operating the wipers. Failure to follow the guidance could cause damage to the wiper blades, arms, mechanism, or windscreen.
Move the control upward to position (1) to select windscreen intermittent wipe. Rotate the collar (5) between the MIN and MAX marks to adjust the time delay between wipes. As the collar is rotated towards the MAX mark wipe frequency increases.
Move the control upward to position (2) to select windscreen low speed continuous wipe.
Move the control upward to position (3) to select windscreen high-speed continuous wipe.
Move the control downward to position (4), and release, for a single wipe of the windscreen. Hold in the downward position for additional wipes.
Pull the control forward to position (6), and release, to operate the windscreen wash wipe function. Hold the control in the forward position if more washer fluid is required. A drip wipe function clears any residual washer fluid from the windscreen. See DRIP WIPE.
Rotate the end of the control to the INT position (7) to select rear screen intermittent wipe.
Rotate the end of the control to the ON position (8) to select rear screen continuous wipe.
Press and release the end of the control to operate the rear screen wash wipe function. Press and hold the end of the control if more washer fluid is required. The wiper continues to operate for a number of cycles after the end of the control is released.
The windscreen wipers operate automatically when the rain sensing wipers feature is selected and water is detected on the windscreen.
A rain sensor, mounted on the inside of the windscreen behind the rear-view mirror, detects the presence and amount of water on the windscreen.
Move the wiper control upward to position (1) to select the rain sensing wipers feature. See WIPER OPERATION.
Rotate the collar of the wiper control (5) to adjust the sensitivity of the rain sensing wipers feature. As the collar is rotated towards the MAX mark the sensitivity of the feature increases.
The rain sensing wipers feature can be disabled or enabled via the touchscreen as follows:
Settings icon.¹
Exit icon.²
The rain sensing wipers feature:
The speed of the front and rear wipers changes automatically with vehicle speed, if configured to do so.
The speed dependent mode can be enabled or disabled by retailer/authorised repairer.
The front wipers slow to the next lowest speed if the vehicle’s speed drops below approximately 8 km/h (5 mph). The original wiper speed is resumed when the vehicle’s speed increases to over approximately 8 km/h (5 mph).
The frequency of the intermittent rear wiper increases when the vehicle’s speed increases.
If the drip wipe feature is configured, the wipers operate a few seconds after a wash and wipe cycle has finished. The drip wipe feature clears any remaining drips from the windscreen.
The drip wipe feature can be enabled or disabled by a retailer/authorised repairer.
The wipers can be set to park in a higher position than normal, when the vehicle is parked. The wiper arms can then be lifted from the windscreen to limit the possibility of the blades sticking to the glass. Lifting the wiper blades from the windscreen also aids the removal of snow, mud, leaves, etc.
The wipers move to the winter park position when the vehicle’s ignition is switched off. The wipers remain in the winter park position until one of the following occurs:
The winter park position can be disabled or enabled via the touchscreen as follows:
Settings icon.¹
Exit icon.²
The headlight wash feature operates automatically with the windscreen wash.
The feature operates every fourth operation of the windscreen washers. The feature operates if the headlights are switched on and approximately 10 minutes has elapsed since the last headlight wash.
Switching the headlights or the vehicle’s ignition off and back on again resets the cycle. See LIGHTING CONTROL and SWITCHING OFF THE ENGINE.
Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…
Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…
Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…
2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…
2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…
2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…