DEFENDER

2022 Land Rover DEFENDER MAINTENANCE Owner Manual

2022 Land Rover DEFENDER MAINTENANCE

BREAKING-IN

The vehicle is built using high-precision manufacturing methods, but the moving parts of the engine must still settle in relative to each other. The breaking-in process occurs mainly in the first 2 000 mi (3 000 km) of operation.

During the breaking-in period of 2 000 mi (3 000 km), observe and follow the instructions below:

  • Do not fully press the accelerator pedal.
  • Avoid high engine speeds (rpm) until the engine has reached its full operating temperature.
  • Avoid operating the engine in too high a gear at low engine speeds (laboring).
  • Gradually increase engine and road speeds.
  • Avoid extended operation at high engine speeds with abrupt stops.
  • Avoid frequent cold starts followed by short-distance driving. Where possible, allow the engine to reach operating temperature.
  • Longer journeys are more helpful during the breaking-in period.
  • Do not participate in off-road driving, competition driving, track days, sports driving schools, or any similar events.

AIR CONDITIONING (A/C)

WARNING

With reference to US legislation relating to Air Conditioning (A/C) refrigerants, J2845 Technician Training for Safe Service and Containment of Refrigerants Used in Mobile Air Conditioning (A/C) Systems (HFO-1234yf) states that under no circumstances should any part of the A/C system be serviced, dismantled, or replaced by anyone other than suitably qualified and certified personnel. Make sure that the refrigerant is correctly contained at all times. Failure to adhere to the above may result in serious personal injury or death.

WARNING

All replacement parts for the Air Conditioning (A/C) system must be new and equivalent to the manufacturer’s original equipment. All replacement parts must comply with the relevant SAE standard (J2842). Contact a retailer/authorized repairer for advice. Failure to do so may lead to serious personal injury or death.

The following symbols may be used on an under-hood label and are relevant to the refrigerant fluid:

A/C symbol.

Lubricant symbol.

Caution.

Flammable refrigerant.

Required registered technician to service A/C.

Consult the Owner’s Handbook.

OWNER MAINTENANCE

CAUTION

Any significant or sudden drop in fluid levels, or uneven tire wear, should be reported to a qualified technician without delay. Ignoring low fluid levels or uneven tire wear may cause damage to the vehicle.

In addition to the routine maintenance, a number of simple checks must be carried out more frequently.

DAILY CHECKS

DAILY CHECKS

  • Operation of the lights, horn, turn signals, wipers, washers, and warning lamps.
  • Operation of the seat belts and brakes.
  • Look for fluid deposits underneath the vehicle that might indicate a leak. Condensation drips from the Air Conditioning (A/C) system are normal.

WEEKLY CHECKS

  • Engine oil level.
  • Engine coolant level.
  • Brake fluid level.
  • Dynamic response fluid level.
  • Windshield washer fluid level.
  • Tire pressures and condition.
  • Operate the Air Conditioning (A/C) system.
NOTES

The engine oil level should be checked more frequently if the vehicle is driven for prolonged periods at high speeds.

SERVICE INFORMATION

Next service information can be viewed via the touchscreen. To view service information:

  1. Select My Vehicle.
  2. Select Service.
NOTES

Dependent on the vehicle’s specification, different service information and messages are available as part of the flexible servicing strategy.

The service interval displays as a distance left until the next service is due. If the service is overdue, the distance shows as a negative (-) value.

For more information, contact a retailer/authorized repairer.

ARDUOUS DRIVING CONDITIONS

When a vehicle is operated in extremely arduous conditions, more frequent attention must be paid to servicing requirements.

Arduous driving conditions include:

  • Driving in dusty and/or sandy conditions.
  • Driving on rough and/or muddy roads.
  • Frequent wading.
  • Frequent driving at high speeds in high ambient temperatures above 122 °F (50 °C).
  • Frequent driving in severe cold weather down to -40 °F (-40 °C).
  • Frequent driving in mountainous conditions.
  • Frequent trailer towing.
  • Driving in areas using road salt or other corrosive materials on the driving surface.

Contact a retailer/authorized repairer for advice.

ANTI-THEFT SYSTEM

CAUTION

No modifications or additions should be made to the anti-theft system. Such changes could cause the system to malfunction, which increases the risk of theft.

AIR BAG SYSTEM

WARNING

The components that make up the air bag system are sensitive to electrical or physical interference. Electrical and/or physical interference could easily damage the system and cause inadvertent operation or a malfunction of the air bag module. Air bags should only be repaired by an authorized repairer. If the air bags are not repaired correctly, they may not operate correctly during a collision, which may lead to serious injury or death.

To prevent malfunction of the air bag system, always consult a retailer/authorized repairer before fitting any of the following:

  • Electronic equipment such as a mobile phone, two-way radio, or in-vehicle entertainment system.
  • Accessories attached to the front of the vehicle.
  • Any modification to the front of the vehicle.
  • Any modification involving the removal or repair of any wiring or component in the vicinity of any of the air bag system components. The components include the steering wheel, steering column, and instrument and dashboard panels.
  • Any modification to the dashboard panels or steering wheel.

PARTS AND ACCESSORIES

WARNING

The fitting of non-approved parts and accessories, or the carrying out of non-approved alterations or conversions, may be dangerous. Doing so could affect the safety of the vehicle and occupants, and also invalidate the terms and conditions of the vehicle’s warranty.

WARNING

All replacement parts for the Air Conditioning (A/C) system should be new and equivalent to the manufacturer’s original equipment, while complying with the SAE standards. Contact a retailer/authorized repairer for advice. Failure to adhere to the above may lead to serious injury or death.

The extremely flammable symbol may be used on an under-bonnet label. The symbol is relevant to the Air Conditioning (A/C) refrigerant fluid.

The symbol identifies flammable chemicals that have low flash and boiling points, and gases that catch fire when exposed to air.

Jaguar Land Rover Limited accepts no liability for death, personal injury, or damage to property, occurring as a direct result of non-approved modifications. These modifications include but are not limited to: fitment of non-approved accessories, and the carrying out of non-approved conversions to the vehicle.

ROAD TESTING DYNAMOMETERS (ROLLING ROADS)

Any dynamometer testing should only be carried out by a qualified person, familiar with the dynamometer testing and safety procedures practiced by retailers/authorized repairers.

SAFETY IN THE GARAGE

Make sure the following warnings have been read and fully understood. Failure to comply with the safety instructions could result in an accident, leading to serious injury or death.

WARNING

If the vehicle has been driven recently, do not touch the engine, exhaust, or cooling system components until the engine has cooled. Hot components may cause serious injuries.

WARNING

Never leave the engine running when the vehicle is in a garage. Exhaust gases are poisonous and can cause unconsciousness and death if inhaled.

WARNING

The jack is designed for wheel changing only. Never work beneath the vehicle with the jack as the only means of support. Always use correctly-rated vehicle support stands, before putting any part of the body beneath the vehicle. If the wheel changing jack breaks, the vehicle may cause serious injury or death.

WARNING

Keep your hands and clothing away from drive belts, pulleys and fans. Some fans may continue to operate after the engine has stopped and may cause serious injuries.

WARNING

Remove metal wristbands and jewelry before working in the engine compartment. Jewelry may trap the hands in the engine compartment which may cause serious injuries.

WARNING

Do not touch electrical leads or components while the engine is running, or with the ignition switched on. Any moving component may cause serious injuries.

WARNING

Do not allow tools or metal parts of the vehicle to make contact with the battery leads or terminals. Metal contact on electrical terminals may cause electric interference and may lead to serious injuries.

POISONOUS FLUIDS

WARNING

Fluids used in motor vehicles are poisonous and should not be consumed or brought into contact with open wounds. Vehicle fluids may cause serious injuries or infection, which can result in death.

For safety, always read and obey all instructions printed on labels and containers.

USED ENGINE OIL

WARNING

Prolonged contact with engine oil may cause serious skin disorders, including dermatitis and cancer of the skin. Always wash thoroughly after contact.

Pollution of drains, waterways, or soil is illegal. Use authorized waste disposal sites to dispose of used oil and toxic chemicals.

OPENING THE HOOD

WARNING

Before opening the hood, make sure that the ignition is switched off and the smart key is removed from the vehicle. Failure to do so can potentially result in serious injury or death.

  1. Pull the handle, located in the left front footwell.
  2. Pull the hood safety catch, located underneath the center of the hood at the front. Raise the hood.

CLOSING THE HOOD

WARNING

Before closing the hood, make sure that no-one is obstructing the closing area and that hands and clothes are clear. The closing hood may cause serious injuries.

WARNING

Do not drive with the hood secured by the safety catch alone. If the hood opens while driving, it may lead to a collision, which may cause serious injuries or death.

WARNING

When closing the hood, make sure to stand in front of the vehicle. Do not attempt to close the hood while standing at the side of the vehicle. Doing so may result in incorrect latching of the hood, which may cause serious injuries or death.

To close the hood:

  1. Using both hands, lower the hood and let it drop from a height of between 8 to 20 in (20 to 50 cm).
  2. Try to lift the front edge of the hood, near both corners, to check that it is securely engaged.
  3. If the hood lifts slightly, it is not properly latched. Open the hood again, and with a little more force, try again to close it.

UNDER-HOOD COVERS REMOVAL

The following steps describe how to remove the under-hood covers:

  1. Release and remove the turnbuckle clips securing the covers.
  2. Lift the edge of the covers and slide to remove.

UNDER-HOOD COVERS REFITTING

CAUTION

Before refitting the under-bonnet covers, make sure that no pipes, cables, or other items have been trapped between the cover and the casing.

To refit the under-bonnet covers:

  1. Place the cover over the casing. Make sure that the holes are aligned.
  2. Push the cover down firmly. Rotate the turnbuckle clips clockwise to fasten.

FUEL SYSTEM

WARNING

Under no circumstances should any part of the fuel system be dismantled or replaced by anyone other than a suitably qualified vehicle technician. If any parts are replaced by an unqualified person, this may cause interference in the operation of the vehicle, leading to serious injury or death.

WARNING

Make sure sparks and open flames are kept away from the engine compartment. A spark may cause an explosion, which may lead to serious injuries or death.

WARNING

Wear protective clothing, including, where possible, gloves made from an impervious material. Failure to do so may result in serious injury or death.

WARNING

If fuel odor is detected, switch off the vehicle and exit as soon as possible. Contact a suitably qualified vehicle technician. Failure to do so could lead to serious injuries or death.

CHANGING A BULB

NOTES

All lights are either LED or xenon units and must only be replaced by a retailer/authorized repairer.

WIPERS SERVICE POSITION

NOTES

The smart key must remain inside the vehicle while the wiper blades are replaced.

NOTES

Fit only replacement wiper blades that are identical to the original specification.

NOTES

Replace the wiper blades in accordance with the manufacturer’s instructions.

Before changing a wiper blade, the wiper arms must be set in the service position as follows:

  1. Make sure the ignition is switched off.
  2. Switch the ignition on and then off again.
  3. Immediately press the wash/wipe control to its lowest position, as if to command a single wipe. Hold this position while switching on the ignition again. The wipers move to the service position. See WIPER OPERATION.
  4. When the new parts have been fitted, switch the ignition off. The wipers return to the park position.

FOLDING FABRIC ROOF RESET

Make sure that the conditions listed below are met before carrying out the folding fabric sunroof reset procedure:

  • The ambient air temperature is between 41°F to 149°F (5°C to 65°C).
  • The vehicle is at a standstill.
  • The vehicle’s battery is sufficiently charged and the electrical connections are good.

The folding fabric sunroof needs to be reset if the battery is disconnected. Disconnection includes the battery becoming discharged, or an interruption to the power supply while the folding fabric sunroof is being operated.

Once the power supply is restored, reset the folding fabric sunroof as follows:

  1. Switch the ignition on.
  2. Use the switch to close the folding fabric sunroof to the fully closed position. Release the switch. See ELECTRIC WINDOWS.
    WARNING

    Vehicles with a folding fabric sunroof do not have an anti-trap system. Make sure that no occupants have any body parts in a position where they could become trapped. Serious injury or death could occur.

  3. Fully press and hold the front of the folding fabric sunroof switch for 10 seconds to start the reset cycle. Continue to hold the front of the folding fabric sunroof switch until the folding fabric sunroof moves forwards and backwards a small amount.

The folding fabric sunroof can now be operated as normal.

PANORAMIC ROOF BLIND RESET

NOTES

The following procedure also resets the panoramic roof.

The roof blind needs to be reset if the battery is disconnected, becomes discharged, or the power supply is interrupted. The reset procedure is as follows:

  1. Start the engine.
  2. With the roof and blind closed, press the roof close switch firmly and hold for approximately 10 seconds. The roof/blind will make an audible click.
  3. Release the switch.
  4. Within 5 seconds, press and hold the roof close switch again. The roof blind and roof blind opening panel will both fully open, then both close. Release the switch once movement is complete.

The panoramic roof/blind can now be operated as normal.

WINDOW RESET

The windows need to be reset if the battery is disconnected, becomes discharged, or the power supply is interrupted.

Reset as follows:

  1. Close the window fully. See ELECTRIC WINDOWS.
  2. Release the switch. Lift the switch to the close position and hold for 1 second.
  3. Repeat the procedure on each window.
NOTES

Make sure that a minimum of 12V is available at all times. It is recommended to have the engine running while resetting the windows.

Automotive Solutions

Recent Posts

VW Jetta Engine Fuse Box Diagram

Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…

7 months ago

VW Jetta Passenger Fuse Box Diagram

Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…

7 months ago

2023 Ford F-150 Lightning Fuse Box Diagram

Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…

2 years ago

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner’s Manual

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…

2 years ago

2023 Land Rover Range Rover Evoque Exiting The Vehicle Owners Manual

2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…

2 years ago

2023 Land Rover Range Rover Evoque Front Seats Owners Manual

2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…

2 years ago