Make sure that following warnings have been read and understood. Failure to observe the warnings could result in an accident, leading to serious injury or death.
Do not smoke, use an exposed flame, or cause sparks while refueling.
Avoid exposing the fuel gases to any potential sources of ignition.
Switch off the engine when refueling, as it is both a source of extreme temperature and electrical sparks.
When refueling, switch off any personal electronic devices such as cell phones or music players.
Take note of all warnings and instructions given on the label affixed to the inside of the fuel filler flap.
The fuel system is designed to make sure that spillage does not occur. Do not attempt to fill the tank past its maximum capacity.
Make sure that the fuel filler nozzle is fully inserted into the filler neck. If the nozzle is inserted loosely, fuel spillage may occur.
When refueling, make sure that all of the windows, doors, and the panoramic roof are fully closed. Use extreme care and caution if young children or animals are in the vehicle.
Only use containers specifically designed for carrying fuel, and always remove them from the vehicle to fill them.
Use high quality fuel with detergent. Low quality fuel can damage the engine and reduce engine performance.
Do not use leaded fuels, fuels with lead substitutes, e.g., manganese-based, or fuel additives. The vehicle’s emission control systems can be adversely affected, which may affect the vehicle’s warranty coverage.
Fuel system cleaning agents should not be used, unless approved by the vehicle manufacturer. Inadequate cleaning agents may damage the fuel system.
Do not use fuels with an octane rating lower than 87 AKI as severe engine damage may occur.
Do not use leaded fuels, fuels with lead substitutes, e.g., manganese-based or fuel additives. Doing so may adversely affect the vehicle’s emission control systems and affect the vehicle’s warranty.
The vehicle manufacturer recommends the use of premium unleaded gasoline with a minimum octane rating of 91 AKI (Anti-Knock Index). Using the correct fuel specification helps to maintain the vehicle’s performance, fuel economy, and driveability.
If premium unleaded fuel is not available, use unleaded fuel with a lower octane rating, down to a minimum of 87 AKI. Using a lower specification fuel may reduce the vehicle’s performance, increase fuel consumption, cause an audible engine knock, and other driveability problems.
Consult a retailer/authorized repairer if an engine knock is detected, while holding a steady speed on level roads. Also consult a retailer/authorized repairer if a heavy persistent engine knock is detected, even if using fuel to the recommended octane rating. Failure to do so is misuse of the vehicle which is not covered by the vehicle’s warranty.
An occasional, light engine knock when accelerating or climbing hills is acceptable.
Federal law requires that gasoline octane ratings be posted on the pumps.
Do not use fuels containing more than 15% ethanol. Inadequate fuel can reduce engine performance and may cause damage to engine components.
Do not use E85 fuels with 85% ethanol content, as serious engine and fuel system damage will occur.
Fuels containing up to 15% ethanol may be used, e.g., E10 and E15.
Make sure that the fuel has octane ratings no lower than those recommended for unleaded fuel. Most drivers do not notice any operating difference with fuel containing ethanol. If driveability issues are experienced, revert to using fuel containing no more than 10% ethanol. If the issues remain, use premium quality unleaded fuel instead.
Wherever possible, avoid using fuel containing methanol. Using fuel containing methanol may cause serious engine and fuel system damage, which is not covered by the vehicle’s warranty.
Unleaded fuel containing an oxygenate known as Methyl Tertiary Butyl Ether (MTBE) can be used. The ratio of MTBE to conventional fuel must not exceed 15%. MTBE is an ether-based compound derived from gasoline. MTBE has been specified by several refiners as the substance to enhance the octane rating of fuel.
Using an incorrect specification of fuel will cause serious damage to the engine and the exhaust after-treatment system. The vehicle’s warranty does not cover this. If in doubt, contact a retailer/authorized repairer for advice.
Vehicles with a diesel engine require the use of Ultra Low Sulfur Diesel (ULSD) fuel. The sulfur content is in accordance with the American Society for Testing and Materials standard ASTM D975 ULSD, or the World Wide Fuel Charter (WWFC) standards. The fuel must also meet the Environmental Protection Agency (EPA) standards.
This vehicle must be operated only with ultra low sulfur diesel fuel (that is, diesel fuel meeting EPA specifications for highway diesel fuel, including a 15 ppm sulfur cap).
Reformulated gasoline is specially formulated to help further reduce the vehicle’s exhaust emissions. The vehicle manufacturer fully supports all efforts to protect and maintain the ambient air quality, and encourages the use of reformulated gasoline, where available.
Avoid running out of fuel. Doing so can cause damage to the vehicle’s engine, fuel and emission control systems.
If the vehicle does run out of fuel, a minimum of 1.1 U.S. gallons (4 L) is required to restart the engine. The vehicle should be left with the ignition on for 5 minutes after refueling, before attempting to restart the engine. The vehicle needs to be driven 1 – 3 miles (1.6 – 5 km), in order to reset the engine management and monitoring systems.
If the vehicle does run out of fuel, seeking qualified assistance is advisable.
If the instrument panel displays a warning message, an excessive amount of water has collected in the fuel system. In this event, consult a retailer/authorized repairer as soon as possible. Water in fuel can damage engine components or the fuel system.
Make sure the relevant safety warnings have been read and understood before refueling the vehicle. See SAFETY PRECAUTIONS.
The fuel filler flap is located on the right side of the vehicle, at the rear. To operate, proceed as follows:
When replacing the filler cap, turn it clockwise until the ratchet clicks.
To close the filler flap, push the flap until it is securely latched.
Make sure that the vehicle is refueled shortly after the refueling button is pressed. Failure to do so may result in the fuel tank not being filled to the required level. If in doubt, check the fuel level gauge in the instrument panel before continuing the journey, to prevent running out of fuel.
To enable refueling, carry out the following:
The isolation valve on the fuel tank remains open for approximately 10 minutes, at which point the valve shuts, preventing further refueling. If further refueling is required, repeat the above process from step 2 to open the isolation valve on the fuel tank.
Make sure that the vehicle is stationary. The fuel filler flap does not unlock, and the isolation valve on the fuel tank does not open, if the vehicle is moving. The instrument panel displays a message to confirm that the vehicle’s speed is too high.
Make sure that the fuel filler flap is closed after refueling. The instrument panel displays a message to confirm that the fuel filler flap is not fully closed.
If a fault is detected on either the fuel filler flap system, or on the isolation valve system on the fuel tank, the instrument panel displays a message. In this event, consult a retailer/authorized repairer or roadside assistance. See INCONTROL REMOTE SMARTPHONE APP.
Make sure the relevant safety warnings have been read and understood before refueling the vehicle. See SAFETY PRECAUTIONS.
Check the fuel pump information carefully, to make sure that the correct fuel is used to refuel the vehicle. Inadequate fuel can reduce engine performance and may cause permanent damage to engine components.
If the vehicle is filled with the incorrect fuel, it is essential to seek qualified assistance before starting the engine. Inadequate fuel can reduce engine performance and may cause permanent damage to engine components.
Filling station pumps are equipped with automatic cut-off sensing to avoid fuel spillage. Fill the tank until the filler nozzle automatically cuts off the supply. Do not attempt to fill the tank beyond this point.
Avoid the risk of running out of fuel. Never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refueling the vehicle after the indicated range reads zero, it may not be possible to add the maximum fuel quantity. The fuel tank retains a small reserve of fuel. See CAPACITIES.
Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…
Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…
Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…
2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…
2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…
2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…