2022 Kawasaki Z900 SE Brake Light Switches Owners Manual

2022 Kawasaki Z900 SE Brake Light Switches

Brake Light Switches

Brake Light Switch Inspection

• Turn the ignition switch on.
• The brake light should go on when the front brake is applied.
• If it does not, ask your authorized Kawasaki dealer to inspect the front brake light switch.
• Check the operation of the rear brake light switch by depressing the brake pedal. The brake light should go on after the proper pedal travel.

A. Brake Pedal
B. 6 mm (0.24 in.)

If the light does not come on, adjust the rear brake light switch.

Brake Pedal Travel
6 mm (0.24 in.)

Brake Light Switch Adjustment

• Remove the right front footpeg bracket bolts.
• Pull the footpeg bracket a little bit out- ward.

A. Right Front Footpeg Bracket Bolts
B. Right Front Footpeg Bracket

To adjust the rear brake light switch, move the switch up or down by tum- ing the adjusting nut.

A. Rear Brake Light Switch
B. Adjusting Nut
C. Lights sooner
D. Lights later

• Install the right front footpeg bracket.
• Tighten the right front footpeg bracket bolts to the specified torque.

Tightening Torque
Front Footpeg Bracket Bolts: 25 (2.5 kgf•m, 18 ft•lb)

NOTE
lf a torque wrench is not available, this item should be serviced by an authorized Kawasaki dealer.