2022 Kawasaki Z900 SE Brake Light Switches
Brake Light Switches
Brake Light Switch Inspection
- Turn the ignition switch on.
- The brake light should go on when the front brake is applied.
- If it does not, ask your authorized Kawasaki dealer to inspect the front brake light switch.
- Check the operation of the rear brake light switch by depressing the brake pedal. The brake light should go on after the proper pedal travel.
A. Brake Pedal
B. 6 mm (0.24 in.)
If the light does not come on, adjust the rear brake light switch.
Brake Pedal Travel
6 mm (0.24 in.)
Brake Light Switch Adjustment
- Remove the right front footpeg bracket bolts.
- Pull the footpeg bracket a little bit out- ward.
A. Right Front Footpeg Bracket Bolts
B. Right Front Footpeg Bracket
To adjust the rear brake light switch, move the switch up or down by tum- ing the adjusting nut.
A. Rear Brake Light Switch
B. Adjusting Nut
C. Lights sooner
D. Lights later
- Install the right front footpeg bracket.
- Tighten the right front footpeg bracket bolts to the specified torque.
Tightening Torque
Front Footpeg Bracket Bolts: 25 (2.5 kgf•m, 18 ft•lb)
NOTE
lf a torque wrench is not available, this item should be serviced by an authorized Kawasaki dealer.