2022 Kawasaki Z125 Pro Specifications Owners Manual

2022 Kawasaki Z125 Pro Specifications

Specifications

PERFORMANCE
Minimum Turning Radius 2.3 m (7.5 ft)

DIMENSIONS

• Overall Length 1 700 mm (66.93 in.)
• Overall Width 750 mm (29.5 in.)
• Overall Height 1 005 mm (39.57 in.)
• Wheelbase 1 175 mm (46.26 in.)
• Road Clearance 155 mm (6.10 in.)
• Curb Mass 102 kg (225 lb)

ENGINE

• Type SOHC, single-cylinder, 4-stroke, air-cooled
• Displacement 125 cm3 (7.63 cu in.)
• Bore x Stroke 56.0 x 50.6 mm (2.20 x 1.99 in.)
• Compression Ratio 9.8:1.
• Starting System Electric starter
• Fuel System Fl (Fuel Injection)
• Ignition System Battery and coil (transistorized ignition)
• Ignition Timing (Electronically advanced) 00 BTDC @1 800 r/min (rpm) 370 BTDC 000 r/min (rpm)
• Spark Plug:
  • TypeNGK CR6HSA
  • Gap 0.6 0.7 mm (0.024 0.028 in.)
• Lubrication System Forced lubrication (wet sump)
• Engine Oil:
  • Type API SG, SH, SJ, SL or SM with JASO MA, MAI or MA2
  • Viscosity SAE low-40
  • Capacity 1.0 L (1.1 US qt)

TRANSMISSION

• Transmission Type 4-speed, constant mesh, return shift
• Clutch Type Wet, multi disc
• Driving System Chain drive
• Primary Reduction Ratio 3.409 (75/22)
• Final Reduction Ratio 2.143 (30/14)
• Overall Drive Ratio 7.940 (Top gear)
• Gear Ratio:
  • 1st 3.000 (36/12)
  • 2nd 1.938 (31/16)
  • 3rd 1.350 (27/20)
  • 4th 1.087 (25/23)

FRAME

• Caster 26.00
• Trail 69 mm (2.7 in.)
• Tire Size:
  • Front 100/90-12 49J
  • Rear 120/70-12 51L
• Rim Size:
  • Front 12 x MT2.50
  • Rear 12 x MT3.50
• Fuel Tank Capacity 7.4 L (2.0 US gal)
• Brake Fluid:
  • Front DOT3 or DOT4
  • Rear DOT3

ELECTRICAL EQUIPMENT

• Battery 2 v 35 w
• Headlight:
  • High Beam 12 V 3 Ah (10 HR)
  • Low Beam 12 v 35 w
• Brake/Tail Light LED

Even if one of LED (Light Emitting Diode) brake/tail light does not go on, consult with an authorized Kawasaki dealer.

Brake/TaiI Light
The brake/tail light goes on as below.

A. When the ignition switch is turned on.
B. When the brakes are applied.

When the ignition switch is turned on, some LED does not go on, however, it is normal. Specifications are subject to change without notice.