2022 Kawasaki Vulcan 1700 Vaquero ABS Starting the Engine Owners Manual

2022 Kawasaki CONCOURS 14 ABS LOGO PRODUCT

2022 Kawasaki Vulcan 1700 Vaquero ABS Starting the Engine

2022-Kawasaki-Vulcan-1700-Vaquero-ABS-Product-Image

Starting the Engine

Check that the engine stop switch is in position.

2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-85A. Engine Stop Switch
B. Starter Button

NOTICE
This motorcycle has ETV (Electronic Throttle Valve) system. After the ignition switch is turned off, the throttle valve opens and closes for about 6 seconds. Do not remove the battery or fuse during this open/close operation.

  • Insert the ignition key.
  • Turn the ignition key to “ON”.

2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-86A. Ignition Switch
B. ON Position

Make sure the transmission is in neutral.

2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-87A. Neutral Indicator Light

NOTE

  • The motorcycle is equipped with a vehicle-down sensor, which causes the engine to stop automatically when the motorcycle falls down. After righting the motorcycle, first turn the ignition key to “OFF” and then back to “ON” before starting the engine.
  • Without holding the throttle grip, push the starter button to start the engine after meter initial operation is finished

NOTICE
Do not operate the starter continuously for more than 5 seconds, or the starter will overheat and the battery power will drop temporarily. Wait 15 seconds between each operation of the starter to let it cool and the battery power recover.

NOTE
The motorcycle is equipped with a starter lockout switch. This switch is designed so that the engine does not start if the transmission is in gear and the side stand is down. However, the engine can be started if the clutch lever is pulled and the side stand is fully up.

2022-Kawasaki-VULCAN-1700-VAQUERO-ABS-fig-88A. Clutch Lever
B. Starter Lockout Switch

NOTICE
Do not let the engine idle longer than five minutes, or engine overheating and damage may occur.

Leave a Comment