2022-Kawasaki-VERSYS-650-ABS-Featured-Image

2022 Kawasaki VERSYS 650 ABS Engine Oil Owners Manual

by
Contents hide
1 2022 Kawasaki VERSYS 650 ABS Engine Oil
2 Engine Oil
2.1 Oil Level Inspection

2022 Kawasaki CONCOURS 14 ABS LOGO PRODUCT

2022 Kawasaki VERSYS 650 ABS Engine Oil

2022-Kawasaki-VERSYS-650-ABS-Product-Image

Engine Oil

Oil Level Inspection

  • If the engine is cold, start the engine and run it for several minutes at idle speed
  • Stop the engine, then wait several minutes until the oil settles.

NOTICE
Racing the engine before the oil reaches every part can cause engine seizures.

  • Check the engine oil level through the oil level inspection window. With the motorcycle held level, the oil level should come up between the upper and lower level lines next to the oil level inspection window.

2022-Kawasaki-VERSYS-650-ABS-fig-19

A. Oil Level Inspection Window
B. Oil Filler cap
C. Upper-Level Line
D. Lower Level Line

  • If the oil level is too high, remove the excess oil through the oil filler opening using a syringe or some other suitable device.
  • If the oil level is too low, add oil to reach the correct level. Use the same type and brand of oil that is already in the engine.

Oil and/or Oil Filter Change

  • Remove the bolts and left lower fairing.

2022-Kawasaki-VERSYS-650-ABS-fig-20

A. Bolts
B. Left Lower Fairing

  • Warm up the engine thoroughly, and then stop it.
  • Place an oil pan beneath the engine.
  • Remove the engine oil drain bolt.

WARNING
Engine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling.

2022-Kawasaki-VERSYS-650-ABS-fig-21

A. Engine Oil Drain Bolt

  • Let the oil completely drain with the motorcycle perpendicular to the ground.
  • If the oil filter is to be replaced, remove the oil filter cartridge and replace it with a new one.

NOTE

  • If a torque wrench or required Kawasaki special tool is not availed- able, this item should be serviced by an authorized Kawasaki dealer.

2022-Kawasaki-VERSYS-650-ABS-fig-22

A. Oil Filter

  • Apply a thin film of oil to the packing and tighten the cartridge to the specified torque.

2022-Kawasaki-VERSYS-650-ABS-fig-23

A. Packing

  • Install the drain bolt with a new gasket. Tighten it to the specified torque.

NOTE

  • Replace the gasket with a new one.

Tightening Torque

  • Oil Filter:
    • 17.5 (1.78 kgf•m, 12.9 ft•lb)
  • Engine Oil Drain Bolt:
    • 30 (3.1 kgfrm, 22 ft.lb)
  • Fill the engine up to the upper-level line with a good quality engine oil specified in the table.

Recommended Engine Oil

  • Type:
    • Kawasaki Performance 4-Stroke Motorcycle Oil* Kawasaki Performance 4-Stroke Semi-Synthetic Oil* Kawasaki Performance 4-Stroke Full Synthetic Oil* or other 4-stroke oils with API SG, SH, SJ, SL, or SM with JASO MA, MAI or MA2 rating
  • Viscosity:
    • SAE low-40
  • Kawasaki Performance Oils and Lubricants have been specifically engineered for your vehicle. Consistent use of these products meets or exceeds warranty and service requirements and can help to extend the life of your Kawasaki.

NOTE

  • Do not add any chemical additive to the oil. Oils fulfilling the above requirements are fully formulated and provide adequate lubrication for both the engine and the clutch.

Engine Oil Capacity

  • 1.6 L (1.7 US qt)
    • [when the filter is not removed]
  • 1.8 L (1.9 US qt)
    • [when the filter is removed]

Although LOW-40 engine oil is the recommended oil for most conditions, the oil viscosity may need to be changed to accommodate atmospheric conditions in your riding area.

2022-Kawasaki-VERSYS-650-ABS-fig-24

  • Install the left lower fairing and tighten the bolts.
  • Start the engine.
  • Check the oil level and oil leakage.

Leave a Comment