2022 Kawasaki VERSYS 1000 SE LT+ Starting the Engine Owners Manual

2022 Kawasaki VERSYS 1000 SE LT+ Starting the Engine

Starting the Engine

Check that the engine start/stop switch is in the O position.

A. Engine Start/Stop Switch

• Turn the ignition key to the “ON” position.
• Make sure the transmission is in neutral.

A. Neutral Indicator (Green)
B. Ignition Switch
C. “ON” Position

NOTE

• While the engine is cold, the fast idle system automatically raises the engine idling speed. At this time, the engine warning indicator may go on if you operate the throttle grip unnecessarily.
• The motorcycle is equipped with a vehicle-down sensor which causes the engine to stop automatically if the motorcycle falls down. After righting the motorcycle, first turn the ignition key to the “OFF” position and then back to the “ON” position before starting the engine.
• Without holding the throttle grip, slide the engine start/stop switch to the position to start the engine.

A. Engine Start/Stop Switch
B. Slide

NOTICE
Do not operate the starter continuously for more than 5 seconds, or the starter will overheat and the battery power will drop temporarily. Wait 15 seconds between each operation of the starter to let it cool and the battery power recovers.

NOTE
The motorcycle is equipped with a starter lockout switch. This switch is designed so that the engine does not start if the transmission is in gear and the side stand is down. However, the engine can be started if the clutch lever is pulled and the side stand is fully up.

A. Clutch Lever
B. Starter Lockout Switch

NOTICE
Do not let the engine idle longer than 5 minutes, or engine overheating and damage may occur.