2022 Kawasaki NINJA ZX-6R Engine Oil
Engine Oil
Oil Level Inspection
- If the engine is cold, start the engine and run it for several minutes at idle speed.
- Stop the engine, then wait several minutes until the oil settles.
NOTICE
Racing the engine before the oil reaches every part can cause engine seizures.
- Check the engine oil level through the oil level inspection window. With the motorcycle held level, the oil level should come up between the upper and lower level lines next to the oil level inspection window.
A. Oil Level Inspection Window
B. Oil Filler cap
C. Upper-Level Line
D. Lower Level Line
- If the oil level is too high, remove the excess oil through the oil filler opening using a syringe or some other suitable device.
- If the oil level is too low, add oil to reach the correct level. Use the same type and brand of oil that is already in the engine.
Oil and/or Oil Filter Change
The oil change and oil filter replacement should be done by an authorized Kawasaki dealer.
WARNING
Engine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling.
A. Engine Oil Drain Bolt
Tightening Torque
Engine Oil Drain Bolt: 29 N.m (3.0 kgfrm, 21 ft•lb)
A. Oil Filter
Tightening Torque
Oil Filter: 17 (1.7 kgf•m, 13 ft•lb)
Recommended Engine Oil
Type:
- Kawasaki Performance 4-Stroke
Motorcycle Oil* - Kawasaki Performance 4-Stroke
Semi-Synthetic Oil’ - Kawasaki Performance 4-Stroke Full
Synthetic Oil*
or other 4-stroke oils with API SG, SH, SJ, SL or SM with JASO MA, MAI or MA2 rating
Viscosity:
SAE low-40
Kawasaki Performance Oils and Lubricants have been specifically engineered for your vehicle. Consistent use of these products meets or exceeds warranty and service requirements and can help to extend the life of your Kawasaki.
NOTE
Do not add any chemical additive to the oil. Oils fulfilling the above requirements are fully formulated and provide adequate lubrication for both the engine and the clutch.
Engine Oil Capacity
Capacity:
2.8 L (3.0 US qt)
[when filter is not removed]
3.1 L (3.3 US qt)
[when filter is removed]
Although IOW-40 engine oil is the recommended oil for most conditions, the oil viscosity may need to be changed to accommodate atmospheric conditions in your riding area.