2022 Kawasaki NINJA ZX-10R Left Handlebar Switches Owners Manual

2022 Kawasaki NINJA ZX-10R Left Handlebar Switches

Left Handlebar Switches

A. Dimmer/Passing Button
B. Upper MODE Button
C. Middle Button
D. Lower MODE Button
E. Horn Button
F. Turn Signal Switch
G. Hazard Button
H. RESET Button
l. Cruise Control Buttons

Dimmer/Passing Button
A high or low beams can be selected with the dimmer/passing button like a trigger. To use the high beam, push the button out. To turn off the high beam, pull the button.To use the high beam for the passing, pull the button. The high beam turns on only while the button is pulled.

A. Push: Dimmer Function (Turning on high beam)
B. Pull: Passing Function/Dimmer Function (Turning off high beam)

High beam… O (High beam indicator: see Meter Instruments section) Low beam… 1) Passing …

NOTE
DO not allow anything to cover the headlight lens when the headlight is on. If covered, heat can build up in the headlight lens causing lens discoloration or melting, as well as damage to the item covering the lens.

Upper/Lower MODE Button
The upper and lower MODE buttons are used for setting the meter and inte• grated riding mode. Meter setting: Riding mode: Refer to the Multifunction Display section. Refer to the Integrated Riding Modes section in the HOW TO RIDE THE MOTORCYCLE chapter.

Middle Button
The middle button is used for setting the meter.

Meter setting: Refer to the Multifunction Display section.

Horn Button
When the horn button is pushed, the horn sounds.

Turn Signal Switch
When the turn signal switch is turned to the left or right( + ) the corresponding turn signal lights and turn signal indicator blinks. To cancel the turn signal, push the switch in.

Hazard Button
Push in the hazard button with the ignition switch in the “ON” position or the “OFF” position. All turn signal lights and turn signal indicators will blink.

NOTE
Be careful not to use the hazard lights for an extended period of time, otherwise, the battery may become totally discharged.

RESET Button
The RESET button is used for setting the meter.

Meter setting: Refer to the Multifunction Display Resetting section.

Cruise Control Buttons
The cruise control buttons are used for setting the cruise control. Cruise control setting: Refer to the Electronic Cruise Control System section in the HOW TO RIDE THE MOTORCYCLE chapter.