2022 Kawasaki NINJA H2 Coolant Owners Manual

2022 Kawasaki NINJA H2 Coolant

Coolant

Coolant Level Inspection

• Position the motorcycle so that it is perpendicular to the ground.
• Check the coolant level through the coolant level gauge on the reserve tank located behind of the right middle fairing. should be between the F (Full) and L (Low) level lines.

A. F (Full) Level Line
B. L (Low) Level Line
C. Reserve Tank

NOTE

• Check the level when the engine is cold (room or atmospheric temperature).
• If the amount of coolant is insufficient, add coolant into the reserve tank.

Coolant Filling
Remove the inner cover bolts.

A. Inner Cover Bolts

Pull up the right inner cover to clear the tabs.

A. Tabs

Pull the right inner cover rearward to clear the projection.

A. Projection
B. Right Inner Cover

Pull the right inner cover rearward to clear the projection.

A. Reserve Tank Cap

NOTE
ln an emergency you can add water alone to the coolant reserve tank, however, it must be returned to the correct mixture ratio by the addition of antifreeze concentrate as soon as possible.

NOTICE
If coolant must be added of ten, or the reserve tank completely runs dry, there is probably leakage in the system. Have the cooling system inspected by your authorized Kawasaki dealer?

• Install the reserve tank cap.
• Insert the projection of the right inner cover into the grommet on the upper fairing.

A. Projection
B. Grommet

Insert the tabs on the right inner cover into the slots of the right fuel tank cover.

A. Tabs
B. Slots

Tighten the inner cover bolts.

Coolant Change
Have the coolant changed by an authorized Kawasaki dealer?

Coolant Requirement

WARNING
Coolant-containing corrosion inhibitors for aluminum engines and radiators include harmful chemicals to the human body. Drinking coolant can result in serious injury or death. Use coolant in accordance with the instructions of the manufacturer. Use a permanent type of antifreeze (soft water and ethylene glycol plus corrosion and rust inhibitor chemicals for aluminum engines and radiators) in the cooling system. On the mixture ratio of coolant, choose the suitable one referring to the relation between freezing point and strength directed on the container.

NOTICE
If hard water is used in the system, it causes scale accumulation in the water passages, and considerably reduces the efficiency of the cooling system.

NOTE 
A permanent type of antifreeze is installed in the cooling system when shipped. It is mixed at 50% and has the freezing point of-35°C (-31°F).