2022 Kawasaki NINJA 1000 SX Starting the Engine
Starting the Engine
Check that the engine start/stop switch is in the O position.
A. Engine Start/Stop Switch
- Turn the ignition key to the “ON” position.
- Make sure the transmission is in neutral.
A. Neutral Indicator (Green)
B. Ignition Switch
C. “ON” Position
NOTE
- While the engine is cold, the fast idle system automatically raises the en- gine idling speed At this time, the engine waming indicator ( ) may go on if you operate the throttle grip unnecessarily
- The motorcycle is equipped with a vehicle-down sensor which causes the engine to stop automatically if the motorcycle falls down. After right- ing the motorcycle, first turn the ig- nition key to the “OFF” position and then back to the “ON” position before starting the engine.
- Without holding the throttle grip, slide the engine start/stop switch to the O position to start the engine.
A. Engine Start/Stop Switch
B. Slide
NOTICE
Do not operate the starter con- tinuously for more than 5 sec- onds, or the starter will overheat and the battery power will drop temporarily. Wait 15 seconds between each operation of the starter to let it cool and the battery power recover.
NOTE
The motorcycle is equipped with astarter lockout switch. This switch is designed so that the engine does not start if the transmission is in gear andthe side stand is down. However, the engine can be started if the clutch lever is pulled and the side stand is fully up.
A. Clutch Lever
B. Starter Lockout Switch
NOTICE
Do not let the engine idle longer than 5 minutes, or engine over- heating and damage may occur.