2022 Kawasaki NINJA 1000 SX Left Handlebar Switches Owners Manual

2022 Kawasaki NINJA 1000 SX Left Handlebar Switches

Left Handlebar Switches

A. Dimmer/Passing Button
B. Upper MODE Button
C. SELECT Button
D. Lower MODE Button
E. Turn Signal Switch
F. Horn Button
G. Hazard Button
H. RESET Button
l. Cruise Control Buttons

Dimmer/Passing Button
High or low beam can be selected with the dimmer/passing button like a trigger. To use the high beam, push the but- ton out. To turn off the high beam, pull the button. To use the high beam for the passing, pull the button. The high beam turns on only while the button is pulled.

A. Push: Dimmer Function (Turning on high beam)
B. Pull: Passing Function/Dimmer Function (Turning off high beam)

• High beam (High beam indicator:
• see Meter Instruments section)
• Low beam
• Passing

NOTE
DO not allow anything to cover theheadlight lens when the headlight is on. If covered, heat can build up in the headlight lens causing lens discoloration or melting, as well as damage to the item covering the lens.

Upper MODE Button
The upper MODE button is used for setting the meter and integrated riding mode.

Meter setting:
Refer to the Multifunction Display section.

Riding mode:
Refer to the Integrated Riding Mode section in the HOW TO RIDE THE MOTORCYCLE chapter.

SELECT Button
The SELECT button is used for setting the meter.

Meter setting:
Refer to the Multifunction Display section.

Lower MODE Button
The lower MODE button is used for setting the meter and integrated riding mode.

Meter setting:
Refer to the Multifunction Display section.

Riding mode:
Refer to the Integrated Riding Mode section in the HOW TO RIDE THE MOTORCYCLE chapter.

Turn Signal Switch
When the turn signal switch is tumed to the left( ) or right( + ) the cor- responding turn signal lights and turn signal indicator blinks. To cancel the turn signal, push the switch in.

Horn Button
When the horn button is pushed, the horn sounds.

Hazard Button
Push in the hazard button with the ignition switch in the “ON” position. All turn signal lights and turn signal indica- tors will blink.

NOTE
Be careful not to use the hazard lights for an extended period of time, otherwise the battery may become totally discharged.

RESET Button
The RESET button is used for setting the meter.

Meter setting:
Refer to the Multifunction Display Resetting section.

Cruise Control Buttons
The cruise control buttons are used for setting the cruise control.

• Cruise Refer to the Electronic
• control Refer to the Electronic
• setting TO RIDE THE MOTORCYCLE chapter.