2022 Kawasaki KX85 Steering
Steering
The steering should always be kept adjusted so that the handlebars will turn freely but not have excessive play.
Steering Inspection
- To check the steering adjustment, raise the front wheel off the ground using a jack (special tool: 57001-1238) and attachment (special tool: 57001 -1608).
- Push the handlebars lightly to either side. If the handlebars continue moving under its own momentum, the steering is not too tight.
- Squatting in front of the motorcycle, grasp the lower ends of the front fork at the axle, and push and pull the front fork back and forth. If play is felt, the steering is too loose and needs to be adjusted.
A. Clamp
B. Number Plate
C. Number Plate Mounting Bolt
D. Projections
- Remove the handlebars (see Adjustable Ergonomics section).
- Loosen the front fork clamp bolts (upper) on both sides (see Front Suspension section).
- Loosen the steering stem head nut.
- Turn the steering stem nut with an adjustable hook wrench (special tool: 57001-1863) to obtain the proper adjustment.
A. Steering Stem Head Nut
B. Steering Stem Nut
C. Adjustable Hook Wrench (Special Tool: 57001-1863)
- If the steering is too tight, loosen the stem nut a fraction of a turn; if the steering is too loose, tighten the nut a fraction of a turn.
- Turn the nut 1/8 turn at a time maximum.
- Tighten the steering stem head nut and the front fork clamp bolts (upper) to the specified torque
Tightening Torque
- Steering Stem Head Nut 65 N m (6.6 kgf-m, 48 ftlb)
- Steering Stem Nut: 5.0 N m (0.51 kgfm, 44 in-Ib)
- Front Fork Clamp Bolts (Upper): 20 Nm (2.0 kgfm, 15 ft:lb)
Install the handlebars (see Handlebar section), and check the steering again and readjust it if necessary. Check the front brake for the proper brake effect, or no brake drag. Check the clutch lever and throttle for the proper operations. Install the number plate so that the projections on the front fender fit into the holes in the number plate.
NOTE
Run the brake hose through the front of the number plate.
A. Number Plate
B. Projections
C. Front Fender
D. Holes
- Tighten the number plate mounting bolt.
- Lock the clamp of the number plate.