2022 Kawasaki KX65 Transmission Oil
Transmission Oil
In order for the transmission and clutch to function properly, maintain the transmission oil at the proper level, and change the oil periodically.
WARNING
Vehicle operation with insufficient, deteriorated, or contaminated transmission oil will cause accelerated wear and may result in engine or transmission seizure, accident, and injury. Check the oil level before each use and change the oil and filter according to the periodic maintenance chart.
Oil Level Inspection
Place the motorcycle perpendicular to the ground. If the motorcycle has just been used, wait several minutes for all the oil to settle. Check the transmission oil level through the oil level inspection window (oil level inspection window) on the lower right side of the engine. The oil should come up to the center of the oil level inspection window. If the oil level is too high, remove the excess oil using a syringe or other suitable device. If the oil level is low, add the correct amount of oil through the oil filler opening. Use oil of the same type and brand as those of the one that is already in the engine.
A. Oil Level Inspection Window
B. Maximum
C. Minimum
D. Oil Filler Cap
E. Center of oil level inspection window
Oil Change
The transmission oil should be changed periodically to ensure long engine life.
- Warm up the engine thoroughly so that the oil will pick up any sediment and drain easily.
- Stop the engine, and place a container beneath it.
- Remove the oil filler cap.
- Remove the oil drain plug and position the vehicle perpendicular to the ground to allow all the oil to drain.
WARNING
Transmission oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling.
- Install the oil drain plug with its new gasket and torque it to 20 Nm (2.0 kgfm, 14 ft 1b).
- Pour in the specified amount of fresh transmission oil.
- Install the oil filler cap.
- Check the oil level after kicking the engine over 3 or 4 times.
Recommended Transmission Oil
Type
Kawasaki Performance 4-Stroke Motorcycle Oil” Kawasaki Performance 4-Stroke Semi-Synthetic oil Kawasaki Performance 4-Stroke Full Synthetic Oil or other 4-stroke oils with API SG, SH, SJ, SL, SM and JASO MA, MA1, MA2 rating
Viscosity:
SAE1OW-40
Kawasaki Performance Oils and Lubricants have been specifically engineered for your vehicle. Consistent use of these products meets or exceeds service requirements and can help to extend the life of your Kawasaki.
NOTE
Do not add any chemical additive to the oil. Oils fulfilling the above requirements are fully formulated and provide adequate lubrication for both the engine and the clutch.
Transmission Oil Total Amount
0.5L L (0.53 US qt) Although 10W-40 engine oil is the recommended oil for most conditions, the oil viscosity may need to be changed to accommodate atmospheric conditions in your riding area.
