2022 Kawasaki KX450X Footpeg Owners Manual

2022 Kawasaki KX450X Footpeg

Footpeg

The right and left footpegs can be mounted onto one of two positions.

• Support the motorcycle using a stand.
• Remove the cotter pin, pivot pin, washer, spring, and footpeg.
  A. Cotter Pin
  B. Pivot Pin
  C. Washer
  D. Spring9
  E. Footpeg
• Remove the footpeg bracket bolts and bracket. (This position is standard.)
  A. Footpeg Bracket Bolts
  B. Footpeg Bracket
• Apply a non-permanent locking agent to the bracket bolts.
• Select either footpeg position and tighten the bracket with the two bolts.
• Tightening Torque
  • Footpeg Bracket Bolts (Upper):
    • 35 Nm (3.6 kgf m, 26 ft b)
  • Footpeg Bracket Bolts (Lower):
    • 17 Nm (1.7 kgfm, 13 ft:b)
• Apply grease to the pivot pin.
• Install the footpeg, spring, and pivot pin. Insert the pivot pin from the front.
• Position the spring ends as shown.
• Replace the cotter pin with a new one.
• Install the washer and new cotter pin.
• Bend the longer end of the cotter pin.
  A. Pivot Pin
  B. Spring Ends
  C. Washer
  D. Cotter Pin

NOTE

• Install the footpegs with the same height on both sides. Do not ride the motorcycle with footpegs installed unevenly.
• Adjust the positions of the shift pedal and the brake pedal to suit the rider’s preference.
• Installing the footpegs in the lower position will reduce the amount of ground clearance and lean angle.