2022 Kawasaki KX450 Footpeg Owners Manual

Contents hide

2022 Kawasaki KX450 Footpeg

The right and left footpegs can be mounted onto one of two positions.

Support the motorcycle using a stand.
Remove the cotter pin, pivot pin, washer, spring, and footpeg.
- A. Cotter Pin
- B. Pivot Pin
- C. Washer
- D. Spring9
- E. Footpeg
Remove the footpeg bracket bolts and bracket. (This position is standard.)
- A. Footpeg Bracket Bolts
- B. Footpeg Bracket
Apply a non-permanent locking agent to the bracket bolts.
Select either footpeg position and tighten the bracket with the two bolts.
Tightening Torque
- Footpeg Bracket Bolts (Upper):
  - 35 Nm (3.6 kgf m, 26 ft b)
- Footpeg Bracket Bolts (Lower):
  - 17 Nm (1.7 kgfm, 13 ft:b)
Apply grease to the pivot pin.
Install the footpeg, spring, and pivot pin. Insert the pivot pin from the front.
Position the spring ends as shown.
Replace the cotter pin with a new one.
Install the washer and new cotter pin.
Bend the longer end of the cotter pin.
- A. Pivot Pin
- B. Spring Ends
- C. Washer
- D. Cotter Pin

NOTE

Install the footpegs with the same height on both sides. Do not ride the motorcycle with footpegs installed unevenly.
Adjust the positions of the shift pedal and the brake pedal to suit the rider’s preference.
Installing the footpegs in the lower position will reduce the amount of ground clearance and lean angle.