2022 Kawasaki KX250 Adjustable Ergonomic Owners Manual

2022 Kawasaki CONCOURS 14 ABS LOGO PRODUCT

2022 Kawasaki KX250 Adjustable Ergonomic

2022-Kawasaki-KX250-Product-Image

Adjustable Ergonomics

To suit various riding positions, the handlebar holder position can be changed and the handlebars can be adjusted by turning the handlebar holders around (180°). The footpeg position can also be changed to suit the rider’s preference.

Handlebar Position Adjustment

  • Remove the number plate (see Steering section).
  • Remove the cover and the handlebar pad.
  • Check the handlebars for damage or cracks.
  • Remove the handlebar clamp bolts, the clamps and the handlebars.2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-1

A. Handlebar Holder
B. Handlebar Clamp Bolts
C. Handlebar Clamps
D. Handlebars

Remove the handlebar holder nuts, washers, handlebar holders and dampers2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-2

A. Handlebar Holder Nuts
B. Washers
C. Handlebar Holder
D. Dampers

Select the handlebar position.2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-3  Install the upper and lower dampers into the steer- ing stem head with aligning the flat surfaces.2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-4

A. Dampers
B. Flat Surfaces

Install the rounded washers and the handlebar holders.

NOTE

  • lnstall the rounded washer so that the round part fits on the damper.
  • Replace the handlebar holder nuts with new ones.
  • Apply engine oil to the handlebar clamp bolts.
  • Put the handlebars onto the handlebar holders.
  • Temporarily install the handlebar clamps.
  • Hand tighten the handlebar clamp bolts.
  • Tighten the handlebar holder nuts to the specified torque

Tightening Torque
Handlebar Holder Nuts: 35 Nm (3.6 kgf-m, 26 ft:lb)

  • Position the handlebars and use the gauge marks to check its alignment in the clamps. should be equal marks showing on each side of the clamps.
  • Tighten the front and rear handlebar clamp bolts equally. If the handlebar clamps are correctly in- stalled, there will be even gaps on the front and rear sides of the clamp after the bolts are torqued.

Tightening Torque
Handlebar Clamp Bolts: 25 Nm (2.5 kgfm, 18 ft:b)

NOTE
Tighten the two clamp bolts alternately two times to ensure even tightening torque.2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-5

A. Handlebar Clamps
B. Clamp Bolts
C. Gap

Install the cover and the handlebar pad so that the fasteners part of the cover faces backward.2022-Kawasaki-KX250-Adjustable-Ergonomic-FIG-6

A. Cover
B. Handlebar Pad
C. Fasteners Part
D. Backward

  • Check the front brake for the proper brake effect, or no brake drag.
  • Check the clutch lever and throttle for the proper operations.
  • Install the number plate (see Steering section).

Leave a Comment