2022 Kawasaki KX112 Spark Plug
Spark Plug
The spark plug should be taken out periodically for inspection and recapping. Measure the gap with a wire-type thickness gauge. If incorrect, adjust the gap to the specified value by bending the outer electrode.
Spark Plug Gap
- NGK R6252K-105.0.8 mm (0.028~0.031 in.)
- NGK BR9EVX 0.6 0.7 mm (0.024 0.028 in.)
- A. Spark Plug Gap
- B. Outer Electrode
If the plug is oily or has carbon built up on it, clean it. The plug may also be cleaned using a high flashpoint solvent and a nonmetal brush (nylon etc.). If the spark plug electrodes are corroded, or damaged, or if the insulator is cracked, replace the plug. The standard spark plug is shown in the table below.
- Standard Spark Plug NGK R6252K-105
- To find out whether the plug’s heat range is correct, remove the plug and examine the ceramic insulator around the center electrode. If the ceramic is light brown, the spark plug correctly matches the engine temperature.
- If the ceramic is burned black, the plug should be replaced with a hotter plug.
Optional Spark Plug
- Hotter NGK BR9EVX
NOTE
lf the engine performance drops, try replacing the spark plug to regain performance.
Spark Plug Removal and Installation
- Clean the cylinder head around the spark plug cap hole before removing the spark plug.
- Pull the spark plug cap off the spark plug.
NOTICE
When removing the spark plug cap, do not pull the lead. The lead could be broken off or damaged the wires inside.
- Apply the spark plug wrench to the spark plug.
- Loosen and remove the spark plug.
- A. Spark Plug Cap
- B. Spark Plug
When reinstalling the spark plug. tighten it to the specified torque.
Tightening Torque
- Spark Plug: 25.5 N m (2.60 kgf-m, 18.8 ftlb)
- Install the spark plug cap.
- Pull up the spark plug cap lightly to make sure of the installation of the spark plug cap.
NOTE
If the engine performance drops, try replacing the spark plug to regain performance.