2022 Kawasaki KX112 Lubrication
Lubrication
Lubricate the areas shown in the illustrations of this section with either motor oil or regular grease,after each race and whenever the vehicle has been operated under wet or rainy conditions, especially after using a high-pressure spray washer. Before lubricating a part, clean off any rust with rust remover and wipe off any grease, oil, dirt, or grime.
General Lubrication
Apply motor oil to the following pivots:
- Clutch Lever
- Front Brake Lever
- Rear Brake Pedal
- Rear Master Cylinder Joint Pin
- Kick Pedal
- Footpeg
- Shift Pedal
Apply an aerosol cable lubricant with a pressure lubricator on all cables:
- Clutch Cable
- Throttle Cable
Cable Lubrication
Apply grease to the following points:
- Clutch Inner Cable Upper End
- Throttle Inner Cable Upper End
- A. Upper End
Drive Chain Lubrication
- Lubrication is necessary after riding through rain or on wet roads, or any time that the chain appears dry.
- Use a lubricant for drive chains. If the chain is especially dirty, clean it using a cleaner for drive chains following the instructions supplied by the chain cleaner manufacturer.
- Apply lubricant to the sides of the rollers so that it will penetrate the rollers and bushings. Wipe off any excess lubricant.
- Wipe off any lubricant that gets on the tire surface.