2022 Kawasaki KX112 Adjustable Ergonomics
Adjustable Ergonomics
Handlebar Removal
Unlock the clamp of the number plate (see Steering section).
Remove the handlebar holder bolts, the handlebar holders, and the handlebars.
- A. Handlebars
- B. Handlebar Holders
- C. Handlebar Holder Bolts
Check the handlebars for bent or cracked.
Handlebar Installation
- Apply 2-stroke oil to the thread of the handlebar holder bolts.
- Install the holders so that the arrow marks on the holders point at the front.
- Align the punch mark on the handlebars with a gap at the rear of the handlebar holder.
- A. Handlebars
- B. Handlebar Holders
- C. Arrow Marks
- D. Punch Mark
- Tighten the front handlebar holder bolts first and then the rear ones. If the handlebar holders are correctly installed, there will be a gap at the rear part after tightening
- A. Handlebar Holders
- B. Gap
- Tightening Torque
-
- Handlebar Holder Bolts: 25 Nm (2.5 kgf m, 18 ftlb)
-
- Check the front brake for the proper brake effect, or no brake drag.
- Check the clutch lever and throttle for the proper operations.
Handlebar Height Adjustment
- The handlebar height can be adjusted in the two positions (5 mm (0.20 in.) or 10 mm (0.39 in.) higher than the standard-setting).
- Remove the handlebars (see Handlebar Removal in this section).
- Remove the handlebar holder nuts and washers, and the handlebar holders.
- A. Handlebar Holders
- B. Handlebar Holder Nuts and Washers
- Select the handlebar height as follows.
- Install the collars between the handlebar holders and steering stem head.
- A. 5 mm (0.20 in.) Higher than Standard Setting
- B. 10 mm (0.39 in.) Higher than Standard Setting
- C. Collars
- D. Handlebar Holder (Both Sides)
- E. Steering Stem Head
- Replace the handlebar holder nuts with new ones.
- Install the handlebar holders, the handlebar holder nuts, and washers.
- Tighten the handlebar holder nuts to the specified torque.
- Tightening Torque
- Handlebar Holder Nuts: 35 N m (3.6 kgfm, 26 ftlb)
- Install the handlebars (see Handlebar Installation in this section).
Handlebar Position Adjustment
- To suit various riding positions, the handlebar position can be adjusted by turning the handlebar holders around.
- Remove the handlebars (see Handlebar Removal in this section).
- Remove the handlebar holder nuts and washers, and the handlebar holders.
- A. Handlebar Holders
- B. Handlebar Holder Nuts and Washers
- Turn the handlebar holders 180°.
- Put the handlebars on the handlebar holders.
- Replace the handlebar holder nuts with new ones.
- Install the handlebar holders, the handlebar holder nuts, and washers.
- Tighten the handlebar holder nuts to the specified torque.
- Tightening Torque
- Handlebar Holder Nuts: 35 N-m (3.6 kgfm, 26 ft-lb)
- Install the handlebars (see Handlebar Installation in this section).