The spark plug should be taken out periodically for inspection and regapping. Measure the gap with a weype thickness gauge. If incorrect, adjust the gap to the specified value by bending the outer electrode.
Spark Plug Gap
CR8E 0.7 0.8 mm (0.028~0.031 in.)
A. Gap
B. Outer Electrode
If the plug is oily or has carbon built up on it, clean it. The plug may also be cleaned using a high flash -point solvent and a nonmetal brush (nylon etc.). If the spark plug electrodes are corroded, or damaged or if the insulator is cracked, replace the plug. The standard spark plug is shown in the table below.
Standard Spark Plug
NGK CRBE
NOTE
NOTICE
When removing the spark plug cap, do not pull the lead. The lead could be broken off or damaged the wires inside.
Tightening Torque
Spark Plug: L 13 Nm (1.3 kgfm, 115 in-lb)
Fit the spark plug cap securely onto the spark plug, and pull the cap lightly to make sure that it is properly installed. Check the spark plug cap lead is not damaged, or correctly routed.
A. Spark Plug Cap
B. Spark Plug
Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…
Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…
Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…
2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…
2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…
2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…