2022 Kawasaki KLX300R Lubrication
Lubrication
Lubricate the areas shown in the illustrations of this section with either motor oil or regular grease,after each race and whenever the vehicle has been operated under wet or rainy conditions, especially after using a high-pressure spray washer. Before lubricating a part, clean off any rust with rust remover and wipe off any grease, oil, dirt, or grime.
General Lubrication
Apply motor oil or grease to the following pivots:
- Clutch lever
- Front brake lever
- Rear brake pedal
- Rear Master Cylinder Joint Pin
- Footpeg
- Shift Pedal
- Side Stand
- Footpeg
- Spring Pin
Cable Lubrication
Apply an aerosol cable lubricant with a pressure lubricator on all cables:
- Clutch Cable
- Throttle Cables
Apply grease to the following points:
- Clutch Inner Cable Upper End
- Throttle Inner Cable Upper Ends
A. Upper End
Drive Chain Lubrication
Lubrication is necessary after riding through rain or on wet roads, or any time that the chain appears dry. Use a lubricant for sealed chains to prevent deterioration of chain seals. If the chain is especially dirty, clean it using a cleaner for sealed chains following the instructions supplied by the chain cleaner manufacturer.
- Apply lubricant to the sides of the rollers so that it will penetrate to the rollers and bushings. Ap-ply lubricant to the seals so that the seals will be coated with lubricant. Wipe off any excess lubricant.
- Wipe off any lubricant that gets on the tire surface.