When the ignition switch is turned on, all indicators go on/off as shown in the table. If any indicator does not operate as shown, have it checked by an authorized Kawasaki dealer.

ON: When ignition switch is turned on.
: After a few seconds
: When engine starts.
: Goes on.
: Goes off.

When Warning Indicators Go On or Blink

When warning indicators appear, there could be a problem with vehicle function. Follow actions in the table after stopping the vehicle in a safe place.
The numbers in this column corresponds to reference numbers on page 49

Other Indicators

Speedometer/Tachometer

A. Speedometer
B. Tachometer
C. Red Zone

Speedometer

The speedometer is digital and can be set for km/h or mph. The unit setting can be changed according to local regulations. Make sure the unit setting (km/h or mph) is correctly displayed before riding. Refer to the Unit Setting in the Display Setting section.

Tachometer
The tachometer shows the engine speed in revolutions per minute (r/min, rpm).
NOTICE
Engine speed should not be allowed to enter the red zone; operation in the red zone will overstress the engine and may cause serious engine damage.

When the ignition switch is turned on, the tachometer gauge momentarily Sweeps from the minimum to the maximum reading, then back the minimum reading. If the tachometer does not operate correctly, have it checked by an authorized Kawasaki dealer.

Display Setting

WARNING
For safety, do not operate the meter buttons while riding the motorcycle.

Multifunction Display

Push the MODE button to select the items shown below. The display items are switched in the following order.
: When occur
:Flow when pushing MODE button

Odometer

The odometer shows the total distance. This meter cannot be reset.
NOTE
When the figures come to 999999, the display is stopped and locked.

Trip Meter

The trip meter shows the distance traveled since it was reset.
NOTE
When the trip meter reaches 999.9 (TRIP A) or 9999.9 (TRIP B) while riding, the meter resets to 0.0 and Continues counting.

How to Reset

Switch the multifunction display to the trip meter.
Push the RESET button and hold it in until the display turns to 0.0.

Fuel Level Warning Message

This message blinks when the fuel level warning indicator appears or blinks.

Unit Setting
Display the correct speed unit according to local regulations.

Switch the multifunction display to the odometer.
Push the RESET button while pushing the MODE button to switch the Speed unit.

Clock Setting

Switch the multifunction display to the odometer.
Push the RESET button and hold it until shifting to the clock setting mode. The hour and minute displays start blinking.
Push the RESET button to select the hour or minute digits.
Push the MODE button to adjust the hour or minute digits.
To finish the adjustment, push the MODE button while blinking the hour and minute digits.

: Flow when pushing and holding
RESET button
: Flow when pushing RESET button
: Flow when pushing MODE button

NOTE
When the battery is disconnected, the clock is reset to 1:00 and starts working again when the battery is connected.

Automotive Solutions