2022 Kawasaki KLX140R Brakes Owner’s Manual

2022 Kawasaki KLX140R Brakes

Brakes

Disc and disc pad wear is automatically compen- sated for and has no effect on the brake lever or pedal action. There are no parts on the brakes that require adjustment except brake lever position.

Brake Lever Position Adjustment

• The brake lever position can be adjusted to suit the rider’s preference
• To adjust the brake lever position, loosen the lock- nut, and turn the adjuster to either side.
• After adjustment, tighten the locknut securely.
  • A. Brake Lever
  • B. Adjuster
  • C. Locknut
• Test the braking power and check that there is no brake drag

WARNING
Air in the brake lines diminish braking perfor mance and can cause an accident resulting in injury or death. If the brake lever or pedal feels mushy when it is applied, there might be air in the brake lines or the brake may be defective. Have the brake checked immediately by an authorized Kawasaki dealer.

Disc Brake Fluid

• Inspect the brake fluid level in the front and rear brake reservoirs and change the brake fluid in accordance with the Periodic Maintenance Chart. The brake fluid should also be changed when contaminated with dirt or water.
• Use only heavy-duty brake fluid as follows.
• Front/Rear Brake Fluid: DOT 3 or DOT 4

NOTE
The motorcycle is shipped with brake filuid DOT4 in the brake system.

NOTICE

• Do not spill brake fluid onto any painted sur- face.
• Do not use fluid from a container that has been left open or that has been unsealed for a long time.
• Check for fiuid leakage around the brake system fittings.
• Check for brake hose damage.

Brake Fluid Level inspection (Front and Rear Brake Reservoirs)

With the front or rear brake reservoir positioned horizontaly, the brake fluid must always be above the lower level line.

• A. Front Brake Reservoir
• B. Lower Level Line

• A. Rear Brake Reservoir
• B. Lower Level Line

If the brake fluid in the front or rear brake reservoir is below the lower level line, check for fluid leaks in the brake line and fill the reservoir to the upper level line. (The step inside the front and rear brake reservoirs indicate the upper level.)

• A. Front Brake Reservoir
• B. Upper Level Line3

• A. Rear Brake Reservoir
• B. Upper Level Line

WARNING
Mixing brands and types of brake fluid can reduce the brake system’s effectiveness and cause an accident resulting in injury or death. Do not mix two brands of brake fluid. Change the brake fluid in the brake line completely if the brake fluid must be refilled but the type and brand of the brake fluid that is already in the reservoir are unidentified.

Brake Pad Wear Inspection

Inspect the brake pads for wear in accordance with the Periodic Maintenance Chart. If the thickness of any pad in any (front or rear) brake caliper is less than 1 mm (0.04 in.), have both pads in the caliper replaced as a set. Pad replacement should be done by an authorized Kawasaki dealer.

Usable Brake Pad Range

• A. Lining Thicknesss
• B. 1 mm (0.04 in.)