When the ignition switch is turned on, all indicators go on/off as shown in the table. If any indicator does not operate as shown, have it checked by an authorized Kawasaki dealer.

ON: When the ignition switch is turned on.
After a few seconds
When the engine starts.
Goes on.
Goes off.
goes off shortly after the motorcycle starts moving.

When Warning Indicators Go On or Blink

When warning indicators appear, there could be a problem with a vehicle function. Follow actions on the table after stopping the vehicle in a safe place.

The numbers in this column correspond to reference numbers on
T: after continuous riding on a rough road.
when the engine is started with the stand raised and the transmission engaged, and the rear wheel turns.
when accelerating so abruptly that the front wheel leaves the ground.
when the ABS has been subjected to strong electrical interference.
when tire pressure is abnormal. Adjust tire pressure. when a tire different in size from the standard size is being used. Replace with a standard size.
when the wheel is deformed. Replace the wheel.

Other Indicators

Speedometer

A. Speedometer

The speedometer is digital and can be set for km/h or mph. The unit sets can be changed ac- cording to local regulations. Make sure the unit setting (km/h or mph) is correctly displayed before riding. Refer to the Unit Setting in the Display Setting section.

Display Setting

Multifunction Display

Push the left meter button or right meter button to select the display modes. The display modes can be shifted in the following order.

NOTE

The multifunction display is displayed in the unit depending on the unit mode setting.
A. Left Meter Button
B. Flow when pushing the left meter button

Odometer The odometer shows the total distance. This meter cannot be reset.

NOTE

When the figures come to 999999, the display is stopped and locked.

Trip Meter

To reset the trip meter

Push the left meter button to select the trip meter A or B.
Push the left meter button and hold it in until the display turns to 0.0.

NOTE

When the trip meter reaches 9999.9 while riding, the meter resets to 0.0 and continues counting.

Unit Setting

Display the odometer in the multifunction display.
Push the right meter button while pushing the left meter button to select the meter display units. The display units can be shifted in the following order.

Clock

To adjust the clock: Push the right meter buttons and hold them until both the hour and minute displays blink.
Push the right meter button and hold it until “12h” or “24h” is appeared on the display.
Push the left meter button to select “12h” or “24h.”
Push the right meter button to select the hour or minute digits.
Push the left meter button to adjust the hour or minute digits.
To finish the clock adjustment, push the right meter button when both the hour and minute digits blink.
A. Flow when pushing and holding right meter buttons
B. Flow when pushing the right meter button
C. Flow when pushing the left meter button

NOTE

When the battery is disconnected, the clock is reset to 1:00 (“24h” dis- play: 13:00) and starts working again when the battery is connected.

Features

Fuel Gauge The fuel in the fuel tank is shown by the number of segments displayed.

A. Segments
B. F (Full)
C. E (Empty)

NOTE

when the fuel tank is full, all the segments are displayed. As the fuel level in the tank goes down, the segments disappear one by one from F (full) to E (empty).
when the fuel level warning indicator and bottom segment blink, refer to the “When Warning Indicators Go On or Blink” of Indicators in this chapter.

Automotive Solutions