2022 Kawasaki KLX 110R Spark Plug Owners Manual

Contents hide

1 2022 Kawasaki KLX 110R Spark Plug

2022 Kawasaki KLX 110R Spark Plug

Spark Plug

The spark plug should be taken out periodically for inspection and recapping. Measure the gap with a wire-type thickness gauge. If incorrect, adjust the gap to the specified value by bending the outer electrode.
Spark Plug Gap
CR6HSA 0.6 0.7 mm (0.024 0.028 in.)

A. Gap
B. Outer Electrode

If the plug is oily or has carbon built up on it, clean it. The plug may also be cleaned using a high flash-point solvent and a nonmetal brush (nylon etc.). If the spark plug electrodes are corroded or damaged, or if the insulator is cracked, replace the plug. The standard spark plug is shown in the table below.
Standard Spark Plug
NGK CR6HSA

SparkPlug Removal and Installation

Clean the cylinder head around the spark plug the hole before removing the spark plug.
Pull the spark plug cap off the plug before removing the spark plug.

NOTICE
When removing the spark plug cap, do not pull the lead. The lead could be broken off or damaged the wires inside.

A. Spark Plug Cap

Apply a suitable wrench to the spark plug.
Loosen and remove the spark plug.
When reinstalling the spark plug, torque it to specification.

Tightening Torque
Spark Plug:
13 Nm (1.3 km, 115 in-1b)
Fit the plug cap securely onto the spark plug, and pull the cap lightly to make sure that it is properly installed.