2022 Kawasaki KLX 110R Spark Arrester Owners Manual

2022 Kawasaki KLX 110R Spark Arrester

Spark Arrester

This vehicle is equipped with a spark arrester. It must be properly maintained to ensure its efficiency. In accordance with the Periodic Maintenance Chart, clean the spark arrester.
NOTICE
The spark arrester must be installed correctly and functioning properly to provide adequate fire protection.
Spark Arrester Cleaning
WARNING
The muffler can become extremely hot during normal operation and cause severe burns. Since the engine must be running during this procedure, wear heat-resistant gloves while cleaning the spark arrester.

• Remove the right side cover (see Air Cleaner section).
• Remove the screws and muffler cover.
  A. Screws
  B. Muffler Cover
• Remove the bolts and pull the spark arrester
  A. Bolts
  B. Spark Arrester
• With a wire brush, remove the carbon off the inside of the spark arrester and muffler.
  A. Spark Arrester
• Install the spark arrester into the rear end of the muffler.
• Tighten the spark arrester mounting bolts.

Tightening Torque
Spark Arrester Mounting Bolts:
8.8 Nm (0.90 km, 78 in-lb)

• Install the muffler cover and tighten the screws.
  Tightening Torque
  Muffler Cover Screws: 3.0 N-m (0.31 km, 27 in-lb)
• Install the removed parts.